1 Remove the plastic cover by unscrewing the 4
screws at the corners.
2 Attach the back of the AKL01P to the wall or in a
suitable location, using the included hardware.
3
4 Wire the device to the AC power supply and zone pumps
using wiring appropriate for 120 VAC. Connect the other
terminals as appropriate to other devices using proper
wiring. Be sure to thread wiring through the knock outs
and use cable clamps to fasten the wiring to the device.
5 Make sure that the fuse is 5A, slow
blow and inserted correctly.
6 Re-attach the plastic cover,
securing it with the 4 screws
and switch on the AC power
to the unit.
The Power LED will come on.
Pump Power
Boiler
Thermostat
AKL01P Zone Pump Wiring Center
Installation Guide
Disconnect the AC
power to the AC wiring
for the device.
FCC Statements and Notices
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning
the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
Industry Canada Notices
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada.
