Salusfin SF 9300 User manual

Smart Plug | SF 9300
User Manual

Introduction
This smart energy plug-in switch is a transceiver which is compatible with
Salusfin Home Gate.
Remote On/Off control of the connected load can be done from Salusfin Mobile
Application. Each switch is designed to act as a repeater. Repeaters will re-
transmit the RF signal to ensure that the signal is received by its intended
destination by routing the signal around obstacles and radio dead spots.
This smart energy plug-in switch is able to detect voltage, current, power factor,
Instant power wattage (5~3150W) and overload wattage (3010~3300W) of
connected light or appliances. When detecting overload state, the Module will be
disabled and it’s On/Off button will be lockout of which LED will flash quickly
for 30 seconds. However, unplug and re-connect the Module will reset its
overload condition to normal status.
This plug-in switch can active sent out instant power wattage when variation
over 5% or active sent out state change when manually push the ON/OFF button,
this allows the controller to avoid polling the reading wattage value and state of
the switch and can increase the efficiency of controller.
Features
•Adopt Z-Wave protocol to secure the success of wireless two way
communication
•Higher RF output power (+2.5dBm output power as compared to 2.5dBm
300 series Z-wave module) to enhance the communication range
•With zero crossing technology to extend the number of switching
•Easy install
•Very low Electricity consumption
•Overload protection

Technical Specification
Power
No load standby power
0.48W (230V)
Input voltage
90 ~240VAC
RF
Frequency
868.42 (EU) MHz
Regulation
FCC part15.249 / EN300 220-1/
Distance
min. 30m indoor min. 100m
outdoor
Mechanical
weight
118 g
Dimension (W x H x D)
57.7x94.5x76.6 mm (Germany type
PAN11-1)
Environment
Operation Temperature
0 ~ 40° C
Humidity
85%RH max
Load
Resistive load
3000W
incandescent load
1500W
fluorescent load
320W
load return error rate
5W~40W
±3W
load return error
rate40W~3150W
±5%
overload
3300W
Mounting Instructions
•Insert the Smart Energy Plug into a socket
•Press the button once
•The LED will light up when the plug is switched on.
•After clicking on the Smart Plug Install button on Home Manager page,
you should get the device ready.
•The system will automatically find the Smart Plug.