Samsung Schneider AD68-01762A User manual

Thank you for purchasing the Schneider D-XENON lens.
This Schneider D-XENON lens features a " Quick-Shift Focus System " that lets you finely
adjust the focus manually after the focus has been adjusted in addition to allowing you to
enjoy taking pictures using autofocus or manual focus by mounting on the SAMSUNG
GX -series digital SLR camera.
For further information on the use of this function, refer to page 12.
Schneider D-XENON lens can be used only with SAMSUNG GX -series SLR
cameras. It is not compatible with film SLR cameras.
Please read this operating manual carefully before using the lens to ensure that it is used
properly. In addition, also refer to your camera’s operating manual.
In this operating manual, "
Schneider D-XENON lens " is shortened to " D-XENON lens. "
Illustrations shown herein may differ from the actual appearance.
FOREWORD

《1》
Although we have carefully designed these lenses for safe operation, please pay special
attention to items marked with the following symbols when using this product.
FOR SAFE USE OF YOUR LENS
WARNING This symbol indicates precautions that if not followed,
could result in serious injury to the user.
CAUTION This symbol indicates precautions that if not followed,
could result in minor or medium injury to the user or
damage to the equipment.
•Never look at the sun through the lens or camera. Serious damage to the retina or total loss of
eyesight may occur.
WARNING
•Do not leave the lens in direct sunlight without lens caps. Direct sunlight passing through the
lens will be intensified, and should it focus on flammable materials, fire may occur.
CAUTION

《2》
1. Storage and mildew prevention
•
Take the lens out of the protective case or camera bag, and store it in a dry, well-ventilated place.
• Avoid storing the lens in a poorly ventilated location such as a closet, wardrobe, drawer, vehicle,
or where insect repellent or medicine is kept.
• Avoid storing the lens in areas of high temperature and humidity, where there is a risk of mildew
growth. Store the lens with a desiccant in a dry cabinet, airtight container, or plastic bag.
(Leaving a saturated desiccant in the storage container can cause damage to the lens. Be sure
to read the instructions that come with the desiccant before use.)
2.
The lens is not waterproof. When using the lens in a rain or mist, be careful not to allow it to get wet.
3. Never use any organic solvent such as thinner, alcohol, or benzine, etc. to remove dust on the lens.
4. The lens is a precise optical instrument. Be careful not to let it fall, or subject it to strong shocks or
pressure. Use a cushion or similar pad to protect the lens from the vibrations of motorcycles or other
vehicles, boats, etc.
5. Avoid subjecting the lens to rapid changes in temperature, otherwise condensation can occur on
both the inside and the outside of the lens. Put the lens in a plastic bag or camera bag, and take it
out after the lens has reached ambient temperature.
6. When the lens is not attached to the camera body, attach both the supplied lens cap and lens
mountcap to protect it from dust.
7. Do not leave the camera with the lens cap off attached to a tripod or other rigid camera support.
The inner parts of the camera can be damaged by direct sunlight.
8. Have the lens inspected by a dealer every one or two years to maintain its high performance.
PRECAUTIONS AND LENS MAINTENANCE

《3》
●FOREWORD
●FOR SAFE USE OF YOUR LENS ...........................................................................................1
●PRECAUTIONS AND LENS MAINTENANCE..........................................................................2
●Schneider D-XENON LENS .....................................................................................................4
■About the lens mount...............................................................................................................5
●MOUNTING AND REMOVING THE LENS ..............................................................................7
●LENS CAP................................................................................................................................8
●FOCUSING...............................................................................................................................9
■Changing the Focus Mode ......................................................................................................9
■Focusing with the OK Button.................................................................................................10
■Focusing with the AF Button..................................................................................................10
■Using the Quick-Shift Focus System (GX -series cameras only)..........................................12
●APERTURE CONTROL..........................................................................................................14
●MACRO LENS ........................................................................................................................15
●ATTACHING THE LENS HOOD .............................................................................................17
●FILTERS .................................................................................................................................18
●PRECAUTIONS WHEN USING THE LENS WITH A FLASH ................................................19
●MAIN SPECIFICATIONS ........................................................................................................20
CONTENTS

《4》
Focusing ring Front-ring threads
Distancescale
Aperture ring
Depth-of-field scale
Aperture-A-lock button
Schneider D-XENON LENS
NOTE :
Aperture settings are controlled automatically as if set to the auto "A" position, so
accessories without an auto "A" setting cannot be used with these lenses.

《5》
About the lens mount
The D-XENON lenses are primarily designed to work with the SAMSUNG autofocus DSLR
(K AF or K AF2
-mount camera), making autofocus shooting possible. When Zoom lenses with
power
zoom function are used on the SAMSUNG K
AF2 -mount camera, the camera features a
Power Zoom system.
Lens-information contacts Power zoom
contacts
AF coupler
KAF mount KAF2 mount
Mounts of Lenses without the power zoom function are K AF .

《6》
CAUTION:
Be careful not to damage or dirty the
lens-information contacts and AF cou-
pler on the mount surfaces of the
camera and lens. Otherwise, failure or
malfunctionmay occur.
Lens Mount Compatibility
D-XENON lens mount compatibility chart is shown below.
KAF2-mount
◦Power contacts
◦AF coupler
◦Lens information contacts
KAF-mount
◦AF coupler
◦Lens information contacts
KA-mount
which is equipped with
◦Lens information contacts
K-mount
(base mount)
which is equipped with
which is equipped with

《7》
12
MOUNTING AND REMOVING THE LENS
1. To mount the lens on the camera body
Attach the lens while aligning the red dots on the lens and body, then turn the lens
clockwise until it clicks in place.
2. To remove the lens
Hold down the lens unlock button on the camera body and turn the lens
counterclockwise.
Memo:
•Do not hold down the lens unlock button while mounting the lens, otherwise the lens
will not be properly mounted.
•After mounting the lens, gently turn the lens counterclockwise to make sure it is locked
in place.

《8》
LENS CAP
Take off the lens cap by pressing the two tabs inward as shown above.
2. Memo:
•When not using the lens, be sure to attach the lens cap.

《9》
Changing the Focus Mode
Use the camera’s focus mode switch to change between the autofocus mode (SAF,
CAF) and manualfocus mode. For details, refer to your camera’s manual.
1. Using Autofocus
Set the camera’s focus mode to autofocus (SAF, CAF). Press the shutter button
halfway to autofocus.
1
FOCUSING

《10》
Focusing with the OK Button
With the GX-1S/1L camera set as explained below, auto focusing by pressing the
shutter button halfway will be disabled and the OK button can be used instead to auto
focus. On the [C Custom menu], select [Enable AF] for [OK btn when shooting].
2. Memo:
•For details on the setting procedure, refer to the camera’s instruction manual.
CAUTION
During autofocusing, the focusing ring will rotate. To prevent malfunction, do not
touch the focusing ring during autofocusing.
Focusing with the AF Button
With the GX-10 camera set as explained below, auto focusing by pressing the shutter
button halfway will be disabled and the AF button can be used instead to auto focus.
On the [CUSTOM1 MENU] menu, select [Enable AF] for [AF Button Function].

《11》
2
2. Using Manual Focus
Set to MF with the camera’s focus mode, and turn the focusing ring to focus manually.

《12》
Using the Quick-Shift Focus System (GX -series cameras only)
If you use the lens with an GX -series camera and the focus mode is set to autofocus,
you can focus manually after autofocus is achieved. Just turn the focusing ring to
manually touch-up the focus. You can do this without changing the focus mode to MF.
How to use the Quick-Shift Focus System
1. Using Autofocus
Set the camera’s focus mode switch to autofocus, then press the shutter button
halfway to autofocus.
With the GX camera set as explained by “Focusing with the OK Button” on page 9,
you can focus by pressing the OK button.
2. Hold down the shutter button halfway (or hold down the OK button) and
then turn the focusing ring to focus.
※ You can focus the subjec with the OK button (GX-1S / 1L) and the AF button (GX-10).
3. Finally, press the shutter release button fully to take a picture.

《13》
CAUTION
During autofocusing, the focusing ring will rotate. To prevent malfunction, do not
touch the focusing ring during autofocusing.
•When using the Quick Shift Focus System, keep pressing the shutter button
after you achieve focus before taking a picture. If you let go of the shutter
button before taking the picture, you will have to focus all over again when
you press the shutter button again. In the following cases, you can take the
picture without autofocusing after letting go of the shutter button.
•With the GX-1S/1L camera, use the [C Custom] menu to set [Cancel AF] for
[OK btn when shooting]. This will enable you to focus manually while you
hold down the OK button. The setting procedure and more details are
explained in the camera’s instruction manual.
•With the GX-10 camera, use the [CUSTOM1 MENU] menu to set [Cancel AF]
for [AF Button Function]. This will enable you to focus manually while you
hold down the AF button. The setting procedure and more details are
explained in the camera’s instruction manual.

《14》
APERTURE CONTROL
32
22
6
1
11
5
8
.6
A
32
2
2
61
8
11
5.6
A
Setting the aperture to "A"(Auto) Turn the aperture ring to align the aperture-A index with
the line while depressing the Aperture-A-lock button. The aperture ring can be released
from "A" in the same manner to set your desired f-stop manually.

《15》
MACRO LENS
Magnification Scale
The magnification is indicated by denomi-
nators on the distance scale. “1” indicates
“1x”. For example, “1” on the magnification
scale at the top will make the magnification
1/1x. If you want to set the magnification
first, turn the focusing ring to set the
desired magnification. Then focus the sub-
ject by moving the camera forward or back.
D-XENON Macro 100mm lenses enable closeup photography up to 1x magnification.
Clamp Switch

《16》
About the Clamp Switch
The D-XENON Macro 100mm lenses are equipped with a Clamp switch which is conve-
nient for manual focus.
The Clamp switch locks the manual focus position. You can use it when taking close-ups
with a copy stand, for example.
Using the Clamp Switch
Focus manually, then set the Clamp switch to ON.
The point of focus will be locked. Autofocus will also be disabled.
• Do not turn the focusing ring forcibly while setting the Clamp switch to ON because
there is a slight possibility that the point of focus may change.

《17》
In order to avoid the deterioration in image quality from internal reflection, use of the lens
hood is recommended.
ATTACHING THE LENS HOOD
When attaching the lens hood, align the index on the lens hood with the attaching index on
the lens, and push both parts straight toward each other. Attach the lens hood on the lens
by turning the hood in the clockwise direction to lock it as viewed from the front of the lens
until it clicks into position.
2. Memo:
•When attaching the lens hood, hold the focus ring securely to prevent them from
turning.
•When the lens hood is not in use, it can also be turned around and attached in the
reversed position.
The lens hood image can be diifferent
depending on the lens hood type.

《18》
Make sure the filter size matches the lens and then attach the filter onto the lens.
2. Precaution on filters
•Since the filter becomes a part of the optics when attached on the lens, handle it in the
same way you handle the lens with care to dust, dirt and scratches. Normally, attaching
two or more filters on a lens is not recommended. However, attaching a circular
polarizing filter and another filter would not be a problem.
•Use a circular polarizing filter with Autofocus camera for proper exposure and
autofocusing.
FILTERS