Samsung VEGA 290W User manual

ENGLISH

2
• This camera will not function without a battery.
• Use one 3V lithium battery(CR-123A or DL-123A).
• The lens cap automatically opens when the Power button is turned on.
• Do not open the lens cap with your fingers.
The shutter does not operate in the following circumstances:
• When the camera has no battery or when the battery is almost drained.
• When the Power is turned off.(When the lens cap is closed.)
• When the zoom button is operating or when the film is winding or rewinding.
(Rewinding will stop when the power button is pressed during rewinding.)
• When the film remains in the camera after rewinding.
• When the flash is being charged.
This camera is controlled electronically by a built-in microcomputer. Although unlikely, it may fail
to operate under certain circumstances in which there is a strong electromagnetic field (near a
TV, microwave etc.). If this occurs, please remove the lithium battery and replace after 2~3
minutes.
NOTE

3
CONTENTS
Part names ................................................................................. 4
LCD panel ...................................................................................7
Viewfinder and Indicators ...........................................................8
Loading the battery .....................................................................9
Checking the battery .................................................................10
Loading the film .........................................................................11
Attaching the strap ....................................................................12
Using the camera.......................................................................13
Holding the camera ..................................................................14
Taking pictures ..........................................................................15
Adjusting the diopter .................................................................16
Buzzer operation .......................................................................17
Rewinding the film ....................................................................18
Date and caption (Q.D. model only)........................................ 19
Using the flash mode ................................................................21
Using the shooting mode .........................................................22
Using the self mode ..................................................................23
Auto red-eye reduction .............................................................24
Auto flash ..................................................................................25
Fill-in flash .................................................................................26
Fill-in flash and red-eye reduction ............................................27
Flash off .....................................................................................28
Spot shooting ............................................................................29
Continuous shooting .................................................................30
Landscape shooting .................................................................31
Bulb shooting(B Shutter) ..........................................................32
Snap shooting ...........................................................................33
Step zoom .................................................................................34
Portrait zoom .............................................................................35
Using the focus lock ..................................................................36
Self-timer ...................................................................................37
Double self-timer .......................................................................38
2 second delayed shutter release ............................................39
Remote control shooting(Optional) ..........................................40
Replacing the battery of the remote control(Optional) ..................41
Panorama photography ............................................................42
Care and storage ......................................................................43
Trouble shooting .......................................................................44
Checking the camera ...............................................................47
PREPARATION
TAKING PHOTOS
IMPORTANT NOTES
SPECIFICATIONS
Thank you for purchasing the SAMSUNG camera. Please read this manual before using your camera.
TABLE OF CONTENTS

4
PART NAMES
Front / Top
Lens
Viewfinder
Power button
Autofocus window
Flash
Self-timer lamp
PREPARATION
Remote control sensor
(Q.D. Model only)
Exposure sensor
Shutter button

5
Rear / Bottom
Autofocus indicator(Green LED)
Flash indicator(Red LED)
Viewfinder
Diopter adjustment dial
Tripod socket
Mid-roll rewind button
LCD panel
Mode dial
Buzzer ON/OFF button
Film check window
Strap eyelet
Back cover release button
Self mode button
DATE or TIME button
(Date and Caption selection button)
Flash button
(Flash mode selection button)
Normal/Panorama switch
Zoom Button(WIDE)
Zoom Button(TELE)

6
Interior
Film sensor
DX contacts
Back cover
Film pressure plate
Film pressure roller
Spool

7
LCD PANEL
Flash mode
Caption Letter indicator
Month
Year
Exposure unit(EX)
Film rewinding indicator
Film present indicator
Film loading indicator
Film loading failure warning indicator(E)
Back-cover open indicator
Battery condition indicator
Buzzer indicator
Remote control shooting
Date or caption print mark
Focal length unit(mm)
Seconds(s) when Bulb mode
Self-timer( )
Double self-timer( )
2 sec. delayed shutter release( ) Focal length
Exposure counter
Date(Year, Month, Date, Time)

8
VIEWFINDER AND INDICATORS
Close range picture area mark
- WIDE : Optimum picture area when shoot within 0.6m~1.5 m
- TELE : Optimum picture area when shoot within 0.7m ~ 2m
Picture area frame
- WIDE : Optimum picture area when shoot over 1.5 m
- TELE : Optimum picture area when shoot over 2m
Autofocus frame (Focus on the subject with this frame)
Indicators
1. Autofocus Indicator (Green LED)
When illuminated this confirms that conditions are suitable for picture taking.
When the subject is too close, (within 0.6m (1.97ft), the LED will blink rapidly and the
shutter will lock. (Refer to page 17 for information of buzzer operation)
2. Flash Indicator (Red LED)
Illuminates when the flash is fully charged. (In low light conditions)
Blinks rapidly when the flash is being charged. (Shutter will be locked)
It blinks quickly if you are out of the range.
Blinks slowly to indicate that the camera requires steady support (preferably a tripod) to
avoid camera shake.
Viewfinder
Green
Red

9
LOADING THE BATTERY
1. Open the chamber cover by sliding the battery chamber cover.
2. Insert a new battery and ensure it is placed in the correct position.
3. Close the chamber cover.
NOTE
Use one CR-123A or DL-123A battery.
The camera will automatically turn the power off when not used after 3 minutes.
Remove the battery from the camera when the camera is not used for an extended period.
Be sure to check the date and shooting mode when you load a new battery.
If the date or time is incorrect, please refer to page 19 and adjust accordingly.
2
1
21
3
21

10
CHECKING THE BATTERY
NOTE
Do not remove the battery while the camera is operating, because it may cause the camera to malfunction.
Battery performance is reduced in low temperatures (under -10 (14 ));Try to keep the camera warm
between shots. (The battery will operate normally again when the temperature returns to
normal).
Please dispose of the exhausted battery with care.
Some local authorities may require batteries to be disposed of separately from other refuse.
1. Normal operation
- The battery condition indicator does not appear.
2. The indicator appears half way.
- The battery life is low and you should ensure that a replacement battery is available.
3. The indicator blinks.
- The battery is exhausted. Load a new battery.
You can check the battery life on the LCD panel

11
LOADING THE FILM
1. Open the back cover by sliding the release knob as shown above.
2. Insert a roll of film in the chamber. Do not force the film into position.
3. The film should lie flat.
4. Close the back cover. It will close with a “click”.
5. The film will automatically advance until the film counter reads “1”.
6. If a film is loaded incorrectly, the LCD panel will display an “E” warning signal. (Refer to page 17 for
information of buzzer operation) Reload the film following the steps shown above.
NOTE
The camera automatically adjusts for ISO 50-3200 DX film.
When you use non-DX film, the camera will set the film speed at ISO 100.
Load the film in subdued lighting.
3
21 4
6
5

12
ATTACHING THE STRAP
Refer to the illustrations above.
3
2
1

13
USING THE CAMERA
Press the Power button to turn the power on. The indicators will appear on the LCD panel.
If the camera is not used for 3 minutes, the power will be turned off automatically.
While looking through the viewfinder, aim the camera at the subject and operate the zoom buttons.
Press the (Tele) button to move the lens out and press the (Wide) button to move the lens
in .
During this operation, the LCD panel shows the focal lengths in the following sequence : 28, 35, 40,
45, 50, 55, 60, 65, 70, 75, 80, 85, 90 mm.
2
1

14
HOLDING THE CAMERA
In order to avoid camera shake, hold the camera
steady, especially when using longer focal lengths
(Tele).
Place the camera strap over your wrist.
Both elbows (horizontal picture) or one elbow (vertical
picture) should be held close to your body.
Keep your eye close to the viewfinder when using the
camera. This ensures correct framing. Ensure you
can see all four sides of the viewing frame when
composing your shot.
NOTE
Avoid obstructing the lens when you take a picture. Pictures can be spoiled when a finger, hair or
camera strap falls in front of the Lens, Exposure Sensor or Auto-focus Windows.
When you take vertical pictures with flash, the flash should be above the lens.

15
Aim the Autofocus frame at a subject.(Refer to page 8)
Press the Shutter button half way down. The lens is focused when the green lamp turns on.
Press the Shutter button all the way down to take a picture.
The film will automatically advance after shooting and the frame counter will advance.
Exposure range (WIDE) : 0.6m ~ (TELE) : 0.7m ~
NOTE
When the flash is being charged, the flash indicator ( ) on the LCD
panel blinks and the shutter will not operate.
When the Red LED blinks slowly, use a tripod or support the camera to avoid camera shake.
In order to avoid camera shake, hold the camera steadily and press the Shutter
button gently, particularly when using longer focal lengths.(Tele)
After taking pictures, turn off the camera. This will protect the lens and prevent
unintended shots. (If not used for 3 minutes, the camera will turn off automatically).
Should a subject be closer than 0.6m, the LED will blink rapidly to indicate that the
subject is too close and the shutter will lock.
Under certain circumstances, the autofocus system will be over-ridden. The camera
will then function, even though the subject is too close.
Some examples of this are :
- A low contrast and bright subject
- Strong light directed towards the camera
- The subject is closer than 0.3m
TAKING PICTURES

16
ADJUSTING THE DIOPTER
Select the maximum zoom setting and turn the diopter adjustment
dial until the viewfinder display becomes clear.

17
BUZZER OPERATION
The buzzer function can be selected by Buzzer ON/OFF
button and it will operate only if the buzzer mark appears
on the LCD panel.
According to the function, the buzzer sound is as follows.
Buzzer sound Function Application
1 short beep Selection When you press Flash, Self, Buzzer button
When Mode Dial is changed
3 beeps Warning When hand shake is detected
3 short beeps Warning/Error When AF Lock (shorter than minimum shooting range) occurs
When a film is loaded incorrectly
When you press Tele/Wide button in the SNAP mode
In case of shooting beyond the scope of flash range.
(Refer to page 21. The function of Auto Flash zoom compensation)
5 long beeps Completion When the rewinding is completely finished

18
REWINDING THE FILM
1. Automatic rewinding
2. Mid-roll rewinding
After taking all the pictures on a roll of film, the camera will automatically
rewind the film. The motor stops when the rewinding is completed.
When the rewinding is completed, the icon ( ) will blink.
You may remove the film at this point. (Refer to page 17 for information of
buzzer operation)
To rewind the film in the middle of a roll, press the Mid-roll rewind button.
The film will be completely rewound, ready for processing. You will not
be able to reload the film.
NOTE
If you press the Power button during film rewinding, the rewinding is
interrupted until the Power button is released.
If the motor stops before the LCD shows “0”, replace the battery. Do not
open the back cover until the battery is replaced.
Rewind button
TAKING PHOTOS

19
DATE AND CAPTION (Q.D.MODEL ONLY)
Press the DATE button to select one of the different formats.
(Refer to the left sequences)
The "PRINT" mark on the LCD panel will blink during the print.
1. Changing "Date" format or selecting the caption
2. Date Zone
<No print>
<Month-Day-Year>
< Year-Month-Day >
<Day-Month-Year>
<Selecting caption print>
<Day-Hour-Minute>
Use the DATE button to control "Date" and "Caption"
<Normal picture>
<Panorama shot>
NOTE
Under certain circumstances, the date will not
print on the final frame of a film.
Printing date and time does not function in
NON Q.D MODEL(TIME is printed beside the
DATE or TIME button on the back cover), but
you can check date and time through the LCD
panel.

20
To change the date or time, press and hold down the DATE button for 2
seconds. The first sector of the date format will blink.
To select the sector that you want to change, press the DATE button.
Change the date setting by operating Zoom buttons. TELE button to increase,
WIDE button to decrease.
NOTE
This camera will set the date automatically until 2099.
A year mark will be indicated by the last 2 digits on the LCD
panel. It will be indicated by 4 digits on the picture.
Under these circumstances the camera will operate as normal.
When the LCD panel shows "CP-1"(refer to the previous picture ), you can select
one of seven captions as follows :
To change the captions, operate the zoom
buttons.("T" or "W")
When caption Mode is selected, message caption
will appear on the LCD panel in order.
NOTE
The camera will print either a date or a caption. You
cannot select both date and caption on the same
picture. (The caption is printed on the date zone).
Remember to reset the date and time after changing
the battery.
3. Changing the date setting
4. Selecting the caption print
Example:
2002 –> “02”
2010 –> “10”
MESSAGE CAPTIONS
CP-1 I LOVE YOU!
CP-2 A HAPPY BIRTHDAY
CP-3 THANK YOU
CP-4 CONGRATULATIONS
CP-5 A HAPPY NEW YEAR
CP-6 MERRY X-MAS
CP-7 HELLO!