
510 Hodge, St-Laurent, QC H4N 2A4
Toll free: 1-877-262-5801, Tel: 514-382-1140, Fax: 514-382-8249, email: marketing@sanisport.ca
INSTRUCTIONS
Prior to first use, please insert the electrical cord into a standard outlet. If your machine has
been shipped overseas, it will have a transformer to accommodate the voltage required.
Please follow the steps below to use the machine:
-Open the cabinet doors by unlocking the black knobs at the top and bottom of the
cabinet
-Place the equipment on the shelves
oLarger items should be on
higher shelves to allow
ozone to circulate
throughout the cabinet
oFor best results, take the
equipment apart as much as
possible (ex: remove all
Velcro from pads, remove
insoles from boots or skates
and place them as separate
items in the machine).
oDo not place items on top of
each other
oFor best results, the
equipment should be dry
-Once all items are placed properly in the cabinet, the operator should close and lock the
doors using the black knobs at the top and bottom of the cabinet
-Turn the power on by pressing the dial
-The green circles around the cycle button signify that the machine is ready for use
-Press the cycle button to start the 12 minute process
-Red dots will appear and then begin to disappear in a circular fashion indicating the time
remaining for that portion of the cycle. The first part of the cycle is generating purified
air through Fan 1. This lasts 3 minutes.
-There will then be 20 seconds of red circles going in opposite directions. This signifies
the change from Fan 1 to Fan 2.
-Fan 2 will then have a 3 minute cycle of generating purified air. This will be shown as red
dots disappearing as was the case with Fan 1.
-Yellow dots will now appear to count down the ozone destruction / waiting period. This
phase lasts 6 minutes.
-Green dots will follow the yellow dots to announce that the cycle is complete and the
equipment can be removed.