Sanipex BAGNODESIGN BDM-CUB-I301 Series User manual

BDM-CUB-I301-XX
CUBE TOUCHLESS BASIN MIXER
(BATTERY OPERATED)
www.sanipexgroup.com

IMPORTANT PLEASE READ
 B 
 

 






 L  C 



 x 
           
          
 



    








 

 







Tools Required (Not supplied)
ON OFF
Always flush pipework before installation
Electrical Cable
Tap comes with pre-installed flexible hoses.

Technical Specification
Electronic faucet
Description
DC: 6V (4AA alkaline battery)
Power
DC: Standby:≤ 0.2mW
Power Consumption
13-4 cm
Sensing distance
0,5 Bar - 5 Bar
Water Pressure
20°- 60°
Temperature
G1/2”
Øof inlet pipet
7.6 L/min
Flux

Battery Holder
X3
Batteries
not included

ON
Do not use any abrasive detergents or solvents containing alcohol, metal or abrasive sponges.

First time use
After setting the initial value of the sensing
distance, the sensor should be not used for 3
minutes. During this period, the sensor repeatedly
scans the use environment, and then automatically
sets the optimal sensing distance according to the
scan parameters.
3 min
Automatically setting the initial value of the sensing distance : The sensor first scans the use
environment 8 times with power on to set the sensing distance.
ATTENTION : do not shake hands or objects at the sensor window during the flash

13 cm
Temperature setting Sensing Distance 13 cm
Timeout protection: when the continuous use
time exceeds 55' seconds, the sensor will
automatically turn off the water, so as to
avoid the phenomenon of continuous water
flow caused by foreign objects in the sensor'
range and waste of water.
>55sec

Dead battery Replace the batteries as shown
on page 2(A)
Dirty sensor Clean the sensor as shown on
page 3 (C)
Light reflections Remove any light reflections
standing in front of the sensor
Electrical problem > Disconnect the battery
> Check the connection
> Check the integrity of the cable
Electrical problem Disconnect and connect the battery
Lack of water supply
Low feed pressure Check the water pressure
Outlet plugged due to
dirt or lime deposits
remove and clean the aerator
as shown on page 3 (A)
Water keeps on running for
more than 1minute without
objects in front of the sensor
Poor water flow
PROBLEM SOLUTION
Reverse the water outlet/inletThe water opens on hot and
gets cold only by adjusting
the lever
?
+ 55se
Water outlet/inlet
reversed the correct
temperature is
shown on (page 5)