Sanipex BAGNODESIGN BDM-REV-315 Series User manual

BDM-REV-315-XX
REVOLUTION CONCEALED 2 HOLE BASIN MIXER
www.sanipexgroup.com

IMPORTANT PLEASE READ
 B 
 

 






 L  C 



 x 
           
           
 



     








 









1 2
1
Assemble the part as per the above. Ensure that
the mains water supply is off before installation.
Install the mixer housing (1) at a depth so that the
finished surface is between the Min/Max distance
in the drawing.
Connect the Hot and Cold water supplies to the
mixer*, then install the mixed water connections
for the spout*. Cap off and pressure test to
prevent any future leakage. Once the surrounding
finishes have been applied (tiles/marble etc.)
remove the front covers (2). Fit the face plate (3)
onto the mixer body. Slide the handle (4) on to the
cartridge pin and secure with the grub screw (5),
then push on the cap (6). Open the water supplies
and test. Fix the support for the spout (7) using
teflon or hamp; fix the spout (8) on the support
using the grub screw (9).
* Before making any inlet pipe connections, all
supply pipes MUST be thoroughly flushed to
remove debris. Failure to do this could result in
damage to the cartridge and components or low
flow from the mixer.

3 4
2
3
4
5
7
6
56
8
9

Note:

Note:

INM-REV-315-XX-11-23
www.sanipexgroup.com