Sanique S-1 Installation and operation manual

S-1
Daily Maintenance Guide
Step-by-step Guide
•Sanitizer Concentrations
•Setting Up
•After-Use & Storage

Here are some important guidelines for the proper use of the SANIQUE S-1 sprayer which are essential
to maintain its reliability over time.
To ensure optimum performance and maintain product reliability, it is essential to keep the hydraulic circuit
clean, free of air bubbles and any residual chemical solution. If the sprayer is used without due care and
attention to the following it is likely to compromise the safer and proper operation of the device.
It is important to bring to your attention that chemical residues can be also caused by an excessive
concentration of sanitizing products commonly in excess of 30%. We understand that emergency
situations may have resulted in an increase in the concentration percentages of the disinfectant, however
this practice should be avoided.
3 Stage Care Procedure
1. When using concentrate disinfectants it is important to adhere to the percentage recommended on
the label of the product used. Do not exceed the advised percentage to avoid the deposit of residues
that could compromise the regular flow of the solution.
2. Before starting, spray a small amount of solution without the nozzle. This operation enables air bubbles
to come out without finding resistance, thus clearing the circuit. After this operation you can install the
nozzle and start sanitizing.
H2
1 2 3 4 5
11 12 13 12
6
1’'
10
87 9
Daily Maintenance Guide

3. At the end of the shift rinse the circuit by spraying just water and immerse the nozzle in a descaling
solution, to prevent any residue from obstructing the flow of the chemical. Spray again without the
nozzle so that all the liquid inside the circuit comes out.
We would strongly recommend that you train your technical staff accordingly, and to convey the importance
of performing the procedures described in this document on a daily basis so as not to compromise the
operation of SANIQUE S-1 sprayer, which, being a professional device, requires proper care.
Failure to follow these guidelines may invalidate your warranty.
pH 2,3 ±
76
60’
53 4
H2
2
9
8
15’'
1

All written and visual data in this document are based on the latest product information available at the time of publication. SANIQUE reserves the right to make changes at any time without
notice.
SANIQUE 2B Stephenstown Industrial Park, Balbriggan, Co. Dublin, K32 KV26
International [phone]
Ireland 1800 714 005
UK 01494 360 751
[email protected]
Daily Maintenance Guide