Sanyo SDH-56 User manual

..... ... ... . . .
-
. ... .
INSTRUCTION MANUAL
DEHUMIDIFIER
Siiqhim
SDH-56/M56
9BF-6-P1 11-18591 C1197-@

Names of Parts
Operation indicator lamp—l
●This lamp is lit while the 1
dehumidifier is in operation.
●This lamp goes out when the
tank is not inserted securely
or when the tank is full.
Air intake
Filter insertion/removal slot
“Full” indicator
Water removed from the air can
be seen dripping here.
Operation automatically stops
when the tank becomes full.
(Rear view>
Drain hose opening —1
●Water removed from the air
can be continuously drained I
On/Off button
Filter
●Insert and remove in
direction indicated by
arrows.
Tank
WJ4Y .Collects water removed from
the air. Insert and remove in
Insert direction indicated by arrows.
(}page 2)
by connecting ahose. L
Operation
-Remove
==$ ,
Handle
—————_
“r
Vent
4l-rCord hook
●Hang the excess cord on the
hook.
Power plug
1
Insert the power plug into an outlet.
.a
%
..
2Press the on/off button.
●The operation indicator lamp will light up and dehumidification -$- ‘N -
will start. OFF-0&’
.,::
Lit ,.,,;, .+:..::.>&
.:;?;‘.;.
3To stop operation, press the on/off button. ::. .&
,,...,......$Press
‘t:::<
o““-
OFF-=-
XOperation will stop automatically when the tank becomes full. o;~l
.:.:.:
@iEio”
●
●
When frost has formed on the cooling device, defrosting will begin
automatically.
During defrosting, the operation indicator lamp remains lit, but the fan does
not operate.
Dehumidification will automatically begin as soon as defrosting is
completed. (}pa9e 2)
-1-

Draining the water
IEmptying the tank I
●When approximately 2.2 liters of water have accumulated in the tank, the operation indicator lamp goes out and the
machine automatically turns off. After the collected water has been emptied, the machine will resume operation
automatically upon reinsertion of the tank.
1
Gently remove the tank and
w‘
‘=~~~ Ij
empty it. (’ i
o,!’
2Slide the tank back in as far
as it will go. #
(~) ●Ifthetankis not securely reinserted the machine will not operate.
9
If the machine should fail to operate
even with the tank inserted, remove and reinsefi it once more.
●If water drips from the main unit while the tank is removed, wipe it up.
●Before moving the dehumidifier, turn it off, and be sure to unplug it and empty the tank, otherwise water
could be spilled onto the floor or elsewhere.
IContinuous drainage
●If the dehumidifier is located near adrainage point, continuous drainage is
possible.
●Turn off and unplug the machine before preparing it for continuous drainage.
●Prepare the drain hose.
~,
1Punch out the drain hose mInstall the drain hose.
Iopening.
Remove the tank
beforehand. ml m
yi~.<i,
Tank
%‘
i ‘ -~!
Drain hose opening
●punch out the opening with ascrewdriver and sm-ooth
the hole with aknife or other such cutting instrument.
mInsert the tank.
a
~
If the tank is not inserted, the “Full” shut-
off mechanism will trigger and prevent
Drain hose opening
Install the hose sec~ \s
and make sure there is 2
no slack in the hose
inside the dehumidifier. ~
If it is difficult to insert the ~
hose, apply some soapy
water to it. >
-.Testthemachine to besureit can drain .rODerlY.
●If the middle of the hose is elevated or crimped, drainage is prevented.
●DO not use the drain hose where the ternpe~atu~e goes below ()”C. Water will freeze inside the hose,
preventing drainage and causing it to overflow on the other end.
Note
I.This machine requires room temperature between
1° and 40”C.
oOutside this temperature range the machine may shut off.
2. During defrosting, the fan does not operate.
●When room temperature is below 18°C frost will form on
the cooling device, which triggers the machine’s
defrosting device. The length of time it takes to defrost
depends on room temperature and humidity.
3. Operation of this machine can raise room
temperature.
●This dehumidifier does not act as an air conditioner, Heat
is generated during operation, which can raise room
temperature by 1to 2degrees Celsius.
4. The amount of moisture drawn from the air varies
according to room temperature.
●As the temperature decreases the dehumidifier will draw
less moisture from the air. It will also draw less moisture
if the machine is operated continuously in the same
room, due to decreased humidity.
5.This dehumidifier will not maintain an especially
low level of humididity (below approximately 50Yo).
–2–

...”. .: ,’..., . .. . . . . . . . . . . .
i
User maintenance
EEl
●It is recommended that the filter be cleaned once everv two weeks.
●Air intake and dehumidifying capacity decrease as dust collects in the filter.
1
Remove the filter 2If the filter is especially 3After the filter is
and vacuum it. dirty, wash it with water. completely dry, reinstall it,
mmiiiKl
1
Wipe the main unit clean
with asoft, dry cloth.
indicator
the front
If the main unit is especially dirty, clean it with aneutral
detergent.
// Do not use
flltl
zo
●Water ho~er than 400C can cause
.deformation and discoloration.
a
(n 3.3 g
3~g. ●Volatile substances can damage the
N32 -
-. Z
m- product.
(%- .%
EEl
.Water in the tank can contain dust and other impurities from the air. If it becomes unsightly, clean the tank.
Removing the cover Mounting the cover
To remove the cover, spread
1
Insert the ribs on e-tier edge
the rim ofthe tank by pulling of the cover securely into 2
on it in either direction, as the holes on the tank.
indicated by the anovvs.
cover
Caution
After mounting the cover,
push on it to make sure
the cover is not loose.
1.Do not place the machine where it will get wet.
●oing so could cause electricalshock or malfunction.
2.Do not operate the machine in very small rooms.
●Increased room temperature could cause malfunction.
3.Do not insert rods or similar objects into the air
intake or the vent.
●Doing so could cause electrical shock or malfunction.
4. Place the machine in asturdy, level location.
.If the machine is tilted it could vibrate and become noisy,
and water could overflow from the tank.
5.Do not allow laundry to fall onto the machine.
6.Do not place the machine where the temperature
becomes hot.
●Doing so could cause deformation or discoloration.
7.Do not apply insecticides or sprays to the machine.
.Doing so could spark afire or cause deformation or cracking.
8.Do not sit or stand on the machine, and do not
knock it over.
.Doing so could cause malfunction.
9.Wait three minutes before restarting the machine.
.The machine has aprotective device which sometimes
prevents it from restarting until three minutes after
dehumidifying comes to astop. Wait approximately three
minutes before restarting. SZWIY
o
–3–
,..,,
SANYO Electric Co., Ltd.
OSAKA, JAPAN
Printed in Japan