Sanyo THS2432 User manual

SUBMITTAL SHEET
SYSTEM INDOOR/OUTDOOR
24THS32 THS2432/CH2432
CEILING SUSPENDED HEAT PUMP
GENERAL DATA (AT 230V)
POWER V/PH/HZ 230/208/1/60
Circuit Ampacity, Min. (A) 30
Fuse size, Max (A) 30
COMPRESSOR Rotary-Hermetic
No. used 1
R.L. Amps - L.R. Amps (A) 9.4 - 66.0
Crankcase Heater 30W
OUTDOOR FAN - TYPE Propeller
Dia. (in.) - No. used 18-3/32- 1
Type Drive - No. speeds Direct ñ 2 (AUTO)
No. Poles - RPM (High) 6 - 879
No. Motors ñ HP 1 - 1/7
CFM (High) 1,840
F.L. Amps. (A) 0.9
OUTDOOR COIL ñ TYPE Aluminum Fin & Copper Pipe
Fin Type - Pipe Type Slit Plate - Inner Riffled
Rows - F.P.I. 2- 14.1
Face Area (sq.ft.) 6.78
Tube Size (in.) 3/8
INDOOR FAN ñ TYPE Centrifugal
Dia. & Length (in.) - No. used 5-1/8 & 4
No. speeds 3 & Auto
No. Poles -RPM (High) 4-1,187
No. Motors - HP 1 - 1/24
CFM (HI/MED/LOW) 540/490/425
F.L. Amps (A) 0.4
INDOOR COIL - TYPE Aluminum Fin & Copper Pipe
Fin Type - Pipe type Slit Plate - Inner Riffled
Rows - F.P.I. 3 - 14.9
Face Area (sq. ft.) 1.81
Tube Size (in.) 3/8
Drain Connection Size (in.) 1-1/4
REFRIGERANT R22
Lbs. - R22 (O.D. Unit) 6.17
Control Capillary Tube
Connection Electronic Refrigerant Control Valve
Line Length, Max (ft.) 165
Lift difference, Max (ft.) 100
Line Size - in. O.D. Discharge 1/4
Line Size - in. O.D. Suction 3/4
DIMENSIONS (in.) H x W x D
Indoor Unit -Uncrated 7- 15/32 x 51- 6/32 x 26-3/8
-Crated 9- 14/32 x 54- 19/32 x 29-31/32
Outdoor Unit-Uncrated 28-15/16 x 37 x 13-3/8
-Crated 32-17/32 x 40 x 16-12/32
WEIGHT INDOOR OUTDOOR
Net (lbs.) 60.0 157.0
Shipping(lbs.) 77.0 170.0
Shipping Volume (cu.ft.) 8.9 12.3
SS24THS32-1
PERFORMANCE DATA @ ARI STANDARD CONDITIONS (230/208V)
COOLING
Total Capacity (BTU/H) 22,400/21,600
Sensible Capacity (BTU/H) 13,640/12,970
Latent Capacity (BTU/H) 8,760/8,630
SEER 10.0/10.0
Dehumidification (Pints/H) 6.3/6.2
Amps (A) 10.7/11.3
Power Inputs (W) 2,290/2,250
HEATING
Total Capacity (BTU/H) 25,400/25,000
HSPF 7.0/7.0
Amps (A) 11.7/12.9
Power Inputs (W) 2,350/2,280
Back-up Strip Heater (KW) 1.80/1.47
Outdoor Sound Rating(bels) 7.6
FEATURE
Controls Microprocessor
Remote Controller LCD Wireless type
Temperature Control IC Thermostat
Timer ON/OFF, 24 hours
Night Setback Built-In
Air Louver (Horizontal) Manual
(Vertical) Automatic
Power Failure Automatic Restart Built-In
Self Diagnosis N/A
OPTION
Refrigerant Line Set AP2710BH (30 ft)
AP2715BH (50 ft)
Low Ambient Control Built-In
Fresh Air Intake N/A
Central Remote ON-OFF Control Available
Airduct Extension N/A
Indoor Frame Extension N/A
Condensate Drain Pump Available
Non-Removable Remo-con Bracket RCS5PS4B
OPERATING RANGE
Cooling Indoor Air Outdoor Air
Intake Temp. Intake Temp.
Maximum 95F DB/71F WB 115F DB
Minimum 67F DB/57F WB 23F DB
Heating Maximum 80F DB/67FWB75F DB/67FWB
Minimum -F DB/ - F WB 17F DB/15FWB
CERTIFICATION
24THS32
AIRCONDITIONING PRODUCTS

Drain connection
Drain connection for left side
Refrigerant liquid line (1/4") Flare connection
Refrigerant gas line (3/4") Flare connection
Hole for rear side refrigerant tubing
Hole for through-the-wall refrigerant tubing (ø3-15/16" hole)
Hole for fresh air intake (Knockout hole)
Hole for right side refrigerant tubing (Knockout hole)
Hole for left side drain connection (Knockout hole)
Hole for power supply (Conduit size 1/2")
Infrared rays receiver for wireless remote controller
Cutting position for fresh air intake
1919_THS_I
Dimension : inch
Air intake
Air outlet
2 ft. or more
Hole for wall-through piping (View from front)
9-7/8
7-15/32
8-7/16
51-3/16
26-3/8
11-1/32
12-7/32
50-13/32
5-25/32
12-19/32 6-5/16 3-3/32
3-3/4
5-25/32
4-23/32
2-17/32
5-9/32
5-25/32
1-3/326-5/16
3-9/324-9/16
5-3/4
7-7/32
4-1/16
9-7/8
5-9/16
1-3/848-7/16 (Suspension bolt hole pitch)
3-1/2
5-25/32
2-25/325-3/16
11-1/32
3-15/16 1-3/8
3-3/8
6-3/32 3-15/16
Front (Service space)(Service space)
Holes in the rear side (View from front)
(Suspension bolt hole pitch)
10
or more
10
or more
WARRANTY
SANYO products are warranted against defects in materials and workmanship for the
period below;
LABOR PARTS
Compressor 30 Days 5 Years
Other Components N/A 1 Year
Because of a policy of continuous product improvements, SANYO reserves the right
to change specifications and design without notice.
Full specific warranty rights, conditions, exclusions and obligations are specified in the
warranty packed with each products.
SANYO FISHER COMPANY
A Division of SANYO North America Corporation
21605 Plummer St. Chatsworth, CA 91311
Phone : [phone]
Fax : [phone]
Website: http://www.sanyohvac.com
Dimensional Data
Indoor Unit: THS2432
Outdoor Unit: CH2432
15-3/4
14-31/32 13/32
1-3/16
1-31/32
28-15/16
11
12-1/16
37
Dimension : inch
Hole for anchor bolt (4-ø1/2)
Refrigerant tube joint (narrow tube)
Flare connection 1/4 in (6.35 mm)
Refrigerant tube joint (wide tube)
Flare connection 3/4 in (19.05 mm)
Refrigerant tubing inlet
Power supply inlet
1131_THS_I
1-31/32
13-3/8
4-21/64266-11/16