
01. Introduction
Welcome Congratulations!
You are now the owner of a Sanyo CO2 ECO, an electric boiler which we
hope will be very much to your satisfaction.
If you use and maintain the Sanyo CO2 ECO correctly you will enjoy
your boiler for many years.
In the following pages you will find the information you look for.
Save this manual together with the technical manual.
General information
The Sanyo CO2 Eco is a complete heat pump system that warms both the
house and the hot water.
The Sanyo CO2 Eco is equipped with a motorized mixing valve which
constantly ensures that a correct and even temperature reaches the radiators.
The Sanyo CO2 Eco has a built-in circulating pump for connection to the heat pump.
The Sanyo CO2 Eco has a micro chip operating system which:
PRQLWRUVDOOfunctions in the product.
DGPLWVLQGLYLGXDODGMustments
FOHDUWH[WVKows the desired values, e.g. temperatures, operation times,
fault indications and so on.
LQDVLPSOHDQGVWUXFWXred way facilitatHVWKHDGMustments and fault
localization.
The Sanyo CO2 Eco has a built-in copper coil which provides domestic hot
water.
The Sanyo CO2 Eco has a basement heating function which makes it
possible to heat only the basement if needed, i.e. summer time. In case of
under floor heating installation it has a electronic controlled temperature limiter.
The Sanyo CO2 Eco has a built-in night reduction, where you can change the
temperature in the house day by day.
The Sanyo CO2 Eco is easy to service with easy access to electrical
components, and good fault tracing functions in the operating
program.
The Sanyo CO2 Eco is delivered with a room sensor as standard. The room
sensor is equipped with a light-emitting diode which alarms in case of fault.
The fault can be read in clear text on the display on the indoor unit (signals
window)
Due to the quick development the right to changes in specifications
and parts are reserved.
Before taking the equipment in use
After the installation check together with the installer that the equipment is in perfect
condition. Let him show you the switches, controls, fuses etc. so that you have a full
understanding of how the equipment functions and must be maintained.
Free the air from the radiators after about three days of operation and if necessary fill
water.
General safety instructions
The following safety instructions must be observed upon handling of the product.
Safety valves (radiator system and primary hot water system) shall regularly be
checked, four times a year. Check that water comes out of the waste pipe.
Never flush the boiler with water.
1HYHUULVNyour safety by dismantling casings, covers etc that are screwed tight.
Never risk your safety by setting safety equipment out of function.
Interventions in the elHFWULF±or hydraulic systems must be done only by a qualified
person
8VHUVPDQXDO