Sapho G7800 Blanice User manual

INSTALLATION AND USER’S GUIDE
Dimensions: WxDxH: (1810 mm x 860 mm x 590 mm)
The warranty will be void if this item is installed with obvious visual defects.
G7800 Blanice
General instructions:
Please take a few minutes to review this manual before you start installation.
Before you begin:
All plumbing installations should be done by a licensed professional plumber/installer.
Observe all local plumbing and building codes.
Caution:
You will need at least two people to install this product properly.
Risk of personal injury. Do not support or lift the bath by the rim. Provide an adequate support under the feet.
SAPHO s.r.o. is not responsible for any damage to the unit or personal property causedby improper installation.
If you disregard instructional warnings, you will void your warranty and possibly deal with water damage.
• Unpack and inspect the bath for damage. Return the bath to the carton until you are ready to install.
• Install the bath on an adequately supported, level floor.
• Before installation, ensure proper access to the final plumbing connections.
Required tools:
• Adjustable keys
• Tape measure
• Pencil
• Level
• Silicone
• Plus : Fabric cloth to protect the bath
Conventional workshop tools.
Bath installation

1A. Remove the bath from its carton and place it on a throw rug or other protective floor covering to prevent
damage to the bath or floor.
1B. Position a clean drop cloth or similar material in the bottom of the bath. Be careful not to scratch the surface
of the bath.
1C. Level the bath by turning the leveling feet at the bottom of the tub.
(You will need two persons to mange this task)
1D. Connect the trap to the drain according to the drain manufacturer’s instructions.
1E. Open the hot and cold water supplies and check all connections for leaks.
1F. Fill the bath to the overflow and check for leaks.
Faucet installation on the bath (optional)
2A. Unscrew the bolts at the bottom of the tub using an adjustable key. Then carefully take out the top of the tub
and place it on a throw rug or other protective floor covering to prevent damage to the bath and the floor.
2B. Drill holes for the faucets on the tub at the desired location. Then install the faucets according to the faucets’
manufacturer’s instructions.
Notes:
• You can choose the location of faucet on the tub according to your convenience. But it is not
recommended to install it in the same location of the overflow.
• Verify all pipe connections to ensure no leakage occurs.
2C. Assemble the top of the tub with the skirt, and secure the bolts at the bottom as shown in the illustration.
2D. Connect the faucet hose with hot and cold water supply and check for leaks.
Maintenance
For the daily maintenance, use a wet cloth and a soft liquid cleaner.
Never use abrasive cleaners containing some acetone, chlorine or strong bleach, scrapers, metallic brushes, nor
other objects or the products which can graze or tarnish surfaces.