The Sapling Company, Inc.
1633 Republic Road
Huntingdon Valley, PA 19006
USA
+1 215.322.6063 P.
+1 215.322.8498 F.
www.sapling-inc.com
9
Web Interface
Network Settings
qGateway IP Address - This field allows for the Gateway IP address to be set.
wSubnet Mask - This field allows the Subnet Mask to be set.
eDNS Router - This field allows for the DNS router address to be set.
rIP Address - This field will display the IP address that was given by the DHCP server. If DHCP is disabled, then the user will be able to
set the repeater’s IP address.
tMAC Address - This read only option is the repeater’s physical address.
yDHCP- This setting allows the user to choose whether the repeater uses DHCP server or not.
uBroadcast to Monitors -This setting allows the repeater to send out its data in broadcast mode.
iSend Specific Monitor IP - This setting allows the user to send the repeater’s status to a computer on a sub-net outside of the
normal network.
oMonitor IP Address - This is where the user will type in the IP address of the specific sub-network in which the repeater’s status will
be sent outside of the normal network if option 8 in enabled.
aEthernet Speed* - Allows the user to either manually set the Ethernet speed at 10MBit, 100MBit, or allows the repeater to Auto
Negotiate the speed with the Network Router/Switch
sConnection Mode* - Allows the user to either manually set the connection mode to Full Duplex, Half Duplex, or allows the repeater to
Auto Negotiate the speed with the Network Router/Switch.
dSubmit - This button, when pressed, saves all of the settings that were changed.
*”Auto Negotiate” is the recommended setting for this feature.
q
w
e
r
t
y
u
io
a
s
d
