Sareer Balatin Daydream Tufted Daybed User manual

Approximate
Assembly Time
20
mins
Daydream Tufted Daybed
BEFORE STARTIN ...
Read the assembly instructions carefully before beginning assembly.
Check and ensure that you have all parts and fittings for complete assembly.
Choose a clean, level, spacious assembly area. Hard surfaces may damage the product.
The packaging and contents can be a choking hazard, therefore keep out of reach
of small chidren at all times.
Do not over tighten the bolts as this may damage the thread.
Two persons are
recommended to
assemble this product
1
995mm
2050mm
1140mm

PART
F
Allen Key
x 1pc
Spanner
x 1pc
D
Hex Nut
x 8pcs
HARDWARE
A
M8 x 25mm
x 4pcs
B
M8 x 40mm
x 2pcs
2
3
1
2
4
5
6
7
8
8
8
8
E
Washer
x 10pcs
C
Threaded rod
x 6pcs

A
F
4
1
2
Screw in the wooden legs and threaded rods to side panels.
Attach the siderail and back panel to the side panels.
3
1
2
3
4
C
3
8
8
C
2
8
8
D
E
E
D
C
C
Back View
1
2
3

3
Attach across rail to the base.
4
Align the pins on the Holders to the holes along the siderail and
back panel. ently tap them into the holes using hand palm.
4
F
B
D
5
E
E
Secure the back panel as shown in diagram.
6
7
5
1
4
2
3

When moving your fully assembled bed you must first remove the mattress and
lift the frame into position, take care when lifting and always have two people
handling the bed. PLEASE DO NOT DRA THE BED as this will cause damage to
the rail.
It is advisable to use approved cleaning products when cleaning the furniture and
bed frame as certain chemical based cleaners could have an adverse effect on the
bed finish.
Retightening of all fixing periodically is recommended.
5
If any queries, please contact your seller.