Sareer Bristol Bed User manual

Bristol 4'6 Bed
Bristol 4'6 Bed
ASSEMBLY INSTRUCTIONS
Before you start:
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product.
2. Take care when lifting. Product should be assembled as near as possible to the point of use.
. Ensure that you have all required contents for complete assembly.
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads.
1-4

2-4
E PLODED E AMPLES
Approximate Assembly
Time: 20mins 2 person needed
FITTINGS
A
C
B
M6x15mm X 4pcs
M6x20mm X 8pcs
E
F
Allen Key X 1pc
M6 Hex Nut X 12pcs
D
M6x50mm X 4pcs
9
5
1
8
6
7
4
2
10
M6x60mm X 4pcs

-4
STEP 1
Attach the Siderails to both
Headend and Footend.Insert
the Finials to Headboard and
Footboard
B
STEP 2
Attach the Centre Rail & Cross
Rail as shown. Followedby the
Support Legs on Centre Rail
5
E
C
4
D
4
9
9
E
A
4
1
2
10
1
1
5
5
4
2

4-4
STEP 3
4
6
8
7
Align the pins on the Plastic Holders
to the holes along the Centre Rails
and the Siderails. Gently tap them
into the holes.
Retightening to all fixing periodically is recommended.
When moving your fully assembled bed you must first remove the
mattress and lift the frame into position, take care when lifting
and always have two people handling the bed. PLEASE DO NOT
DRAG THE BED as this will cause damage to the rail.
It is advisable to use approved cleaning products when cleaning
the furniture and bed frame as certain chemical based cleaners
could have an adverse effect on the bed finish.
All SAREER beds are produced to the highest standards and are
packed to avoid damage in transit, should you find that your new
bed does not meet with your satisfaction please contact
your seller.
8