SBM KIT QDC-DXP User manual

KIT QDC-DXP®
FOR DISC COULTER SEEDERS
To ensure the best preservation of your seeds,
the microgranules need to be well positioned
around the whole depth of the seed using a
QDC-DXP®diffuser.
For this purpose, it is necessary to equip
the micro granulator drop with a diffuser
and to proceed with the assembly according
to the brand and the type of the coulter or
disc planter.
The kits for the QDC-DXP
®
diffusers installa-
tion together with their assembly instructions
are available at your micro granule supplier.
Please follow the installation guidelines to
optimize your micro granule’s efficiency.
»
Application mode
for single seed seeders
(Maize, Sunflower, Sorghum)
It is important to carry out a fine seedbed
preparation to ensure a uniform distribution
of the microgranules over the entire seedbed
section (see diagram below). The coarse
preparations as well as a too deep seeding
must be banned because they do not allow
to realize an effective barrier of protection
with your micro granulate around the seed.
The optimum efficiency is achieved with a
seeding depth of 4 cm.
In case of any doubts, please contact your
distributor.
Choosing a QDC-DXP® diuser, optimizes
the eectiveness of your microgranules
and your seeds preservation!
ASSEMBLY INSTRUCTIONS
Pressure wheels
QDC-DXP®Diffuser
SBM
Microgranules
Graine
Discs
SEED ET SEEDLING PRO
TECTION
SEED +
MICROGRANULES DROP
OPENING FURROW FULL FURROW CLOSURE
Ridge height:
2 to 3 cm
Sowing depth:
4 to 6 cm
iPRODUCT FOR PROFESSIONAL USE: PLEASE RESPECT THE TERMS AND CONDITIONS
ASSEMBLY INSTRUCTIONS

QDC-DXP® DIFFUSER ASSEMBLY
KVERNELAND OPTIMA HDII
Assembly
Remove the factory drop tube from its place
and cut it off 5 cm from its end - Picture 1
Directly fix the 18 mm QDC-DXP®diffuser to
the drop. Place it with the vane facing forward -
Picture 2
The 18 mm QDC-DXP®diffuser needs to be
fitted to the metal tube with the needle screw
supplied with each reducer. In each diffuser
bag there is a hexagonal key provided for this
purpose.
Put the microgranule tube back in its place,
fix it and adjust the microgranule drop of
the seeder on it. Then, check the positioning
after a few hours of operation and generally
throughout your seeding campaign.
»
1 2
To install the diffuser, you must order
the QDC-DXP®ACHDE kit.
Please refer to the pictures of the components
provided in the kit necessary to assemble these
parts on your KVERNELAND Optima HD-II seeder.
»
Kit
Components
Cut 5 cm

ASSEMBLY INSTRUCTIONS
TECHNICAL TEAMS AT YOUR SERVICE
EMAIL ADDRESS
[e-mail]
HOTLINE
+ 33 (0) 6 72 40 94 31
WEBSITE
www.kits-sav.com