Scag Power Equipment CHEETAH User manual

WWW.SCAG.COM
Engine Options:  31hp Kawasaki FX, air-cooled, V-Twin, vertical shaft
 32hp Briggs Vanguard Big Block, air-cooled, V-Twin
 34hp Kawasaki FX, air-cooled, V-Twin, vertical shaft
Fuel Capacity/Design: 15 gallons, dual fuel tanks mounted low on the mower to lower the center-of-gravity
and improve hillside stability and traction.
Travel Control: Twin “Quick-Fit” steering controls with gas dampers for smooth, precise
 maneuverability.Adjustabletotvariousoperatorsizes.
Ground Speed:  16mph forward, 8 mph reverse in high-range
 12mph forward, 5 mph reverse in low-range
Main Frame Construction: Double tube, steel frame, full-length, fully-welded
Drive Tires: 24 x 12 - 12, 4 ply
Caster Tires: 13 x 6.5 - 6, 4 ply; Flat-Free, semi-pneumatic
Caster Wheel Bearings: Tapered roller bearings
Front Caster Arm Design: Bolt-on for easy replacement if necessary
Drive System: Dual Hydro-Gear ZT-5400, 2-speed, integrated transaxles (2 separate units); 16cc
displacement pump; 21cc displacement wheel motor; 9” cooling fan on each unit
Hydraulic Oil Cooling: Yes - 9” fan on each unit
Hydraulic Oil Filter: 40microninternallter
Electrical System: 12 Volt battery, 350 cca. Alternator, 20 amp charging. Solenoid shift starter.
Specications
The Fastest Cat on Earth.
(Continued)

WWW.SCAG.COM
Belts: Kevlar cord. Self-adjusting, spring-loaded, self-tightening
Drive/Load Pulleys: Split-steel design -- stronger and lighter weight than cast-iron
Instrument Panel : Ammeter, key switch, throttle, manual choke, BBC switch, digital SmartSense hour
meter
Operator Suspension System:  Isolates the entire operator station from the effects of rough terrain.
 Coil-over shock provides effective suspension action right where it's needed, and
only where it's needed for a smooth ride.
 High-back seat, fully adjustable, with adjustable, folding arm rests.
 “Quick-Fit” steering control levers feature incredible range of adjustment for optimal
comfort and control
 3-Position adjustable deck lift foot pedal allows for easy deck lift for all operators
PTO - Electric Clutch:  Ogura GT3.5 - 250 ft lb; adjustable air-gap (61” models)
 Ogura GT5 - 350 ft lb; adjustable air-gap (72” models)
Cutter Decks: 61” & 72” Velocity Plus decks. Floating, adjustable, anti-scalping design.
Cutter Deck Construction: Tri-Plate, welded: 10 gauge top, 7 gauge skirts, 7 gauge & 11 gauge
reinforcement plates.
Cutter Deck Drive: Belt-driven -- straight alignment for increased reliability & longevity
Number of Anti-Scalp Wheels:  61": 7 wheels in 5positions
 72": 7 wheels in 5positions
Cutter Deck Spindles: Scag Heavy-Duty Spindles w/cast-iron housing & tapered roller bearings,
backed by 3-year limited warranty
Cutter Deck Height Adjustment: Foot pedal lift (3-position adjustable) with self-locking mechanism at transport position
Cutting Range: 1.25” to 5” in 1/4” increments
Number of Cutter Blades: 3 Marbain blades
Total Length:  61" models: 85.5"
 72" models: 91"
Total Width (with discharge chute in mowing position):
 61" models: 73.5"
 72" models: 83"
Total Width (with discharge chute in transport position):
 61" models: 62.75"
 72" models: 73"
Height (with ROPS): 67”
Height (with ROPS folded): 49.5”
Weight (with ROPS):  61" models: 1350-1360 lbs.
 72" models: 1400 lbs.
Warranty:  2 Yr. Commercial Mower Warranty—Parts & labor.
 3 Yr. / 500 Hour Non-Commercial Mower Warranty—Parts & labor.
 3 Yr. Deck Warranty—First & second years parts & labor; third year parts.
 3 Yr. Spindle Warranty—First & second years parts & labor; third year parts.
 2 Yr. Engine Warranty—Minimum two-year warranty covered directly
through the individual engine manufacturer. (Kohler Aegis covered by 3-year
warranty)
Allspecicationssubjecttochangewithout
notice. Actual ground speeds may vary.