Scale Lean2 User manual

a DeskMakers brand
Lean2
Floor To Surface Screens
INSTALLATION GUIDE

Step 1
Position and level frame on the desk surface. Be sure that all 4 Levelers are
touching the oor (L1, L2), and Desk Surface (L3, L4).
Step 2
Clamp the Frame to the Desk
Surface rmly.
ASSEMBLY INSTRUCTIONS:
L3 L4
L1 L2
2

Step 3
Turn Levelers L1 and L4 clockwise until the frame is tight
against the oor and back of desk surface.
NOTE: If frame is still loose - use a wrench or pliers to tighten
levelers until Frame is solid and secure.
L1
L4
3

SPECIAL WARNINGS:
- DO NOT CLIMB, STAND, OR SIT ON THIS PRODUCT.
- AVOID PLACING EXTREMELY HOT & COLD ITEMS ON THE SURFACE.
CARE and MAINTENANCE:
Clean your LEAN2 with warm water and dry with a soft absorbent cloth towel. Do
not use bleach or solvents to clean this product! This will void the warranty. Lack
of original receipt will void warranty!
IMPORTANT:
Refer to your Dealer for further details of your SCALE 1:1 product purchase
policies. Return policy is strictly under the Dealer discretion. SCALE 1:1 is exempt
of responsibility or accepting product returns direct from a consumer when the
product was not purchased direct from SCALE 1:1’s inventory.
© 2020 Scale 1:1. All Rights Reserved.
www.scale1to1.com
a DeskMakers brand