Scandvik Hot Waves 80001 User manual

Application Marine
Capacity 6 gallons
Internal tank material carbon steel hot roll ASTM-A36 Caps and cylinder thickness 2.4mm
Internally Coated
This protection provides a bond with the metal substrates
and excellent corrosion protection. Powder coating Dupont,
Alesta ELW505S9, in accordance with FDA standards
External cover berglass / gelcoat color white Resistant to corrosion and marine environment / can be
used as step
Polyurethane foam insulation To reduce heat loss
Inner surface preparation Sand-blasting with metal
Particles Type SSPC-10
Clean the inner surface of carbon, oil and corrosion and
prepares for implementation of epoxy
Sacricial magnesium anode Provides corrosion protection that extends the life of the
tank
Inlet / outlet water connections 1/2” NPT-male
Pressure / temperature safety valve coupling 1/2” NPT-female
Pressure / temperature safety valve 210º F and/or 150 psi. Located on the front of the tank the
T&P valve is included
Maximum Operating Pressure 125 psi
Recovery time (ΔT: 45°F) 25 minutes to raise water temperature 45°F
Threaded heating element 110 VAC, 1500 W (available in various wattages and volt-
ages)
Ignition protected xed limit thermostat Temperature adjustment (Low, Medium, High)
Standard engine heat exchanger formed stainless steel Continuous 316 SS tubing, no internal joints
UL & CSA Approvals T&P Valve, Thermostat and Heating Element
Warranty 2-year full warranty, 5-year warranty on tank
www.scandvik.com
[phone]
#80000 W/O Heat Exchanger, 110V
#80001 With Heat Exchanger, 110V
Marine Water Heater User Guide
Can be used as a step

www.scandvik.com
[phone]
T&P Safety Valve connection
1/2” NPT-Female
(T&P Safety Valve included)
Heat Exchanger connection
1/2” NPT-Male
(Model #80001 only)
Water Outlet connection
1/2” NPT-Male
Water Inlet connection
1/2” NPT-Male Heating Element
Ground Connection
(Green Wire)
Thermostat
110 VAC
Connections
Can be used as a step
MADE IN COSTA RICA
Dimensions: 15-5/8” Wide x 12-3/4” High x 15-5/8” Deep
(19-7/8” Deep with T&P Safety Valve installed)
Empty Weight: 28 lbs.
12 Amps at 110 VAC
Warning: Fill tank with water before turning on water heater
to avoid damage to the heating element.
Recommended Service: Inspect/Replace Anode every 3 - 4 years.
Replacement Parts
#80010: Heating Element (110 VAC, 1500 W)
#80011: Thermostat
#80012: Anode (Magnesium) on back of tank