SciCan HYDRIM L110w User manual

HYDRIM®L110 w
Quick Reference Guide
Successful Instrument Washing
• Remove composite, cement and amalgam at chairside
• Do not put burs in Hydrim
• Do not allow instruments to dry for longer than one hour before
processing in Hydrim
• Load cassettes and baskets according to manufacturer’s guidelines.
Do not overload.
• For cassettes and hinged instruments, use the heavy-duty cycle
• Place small / light items in the basket with lid
• Do not put anodized aluminum instruments in Hydrim
How to Use Hydrim
1. Turn the machine ON
2. Touch the screen to begin
3. Touch the unlock symbol
4. Load instruments / cassettes into the machine
5. Close the door
6. Touch the desired cycle. The door will be locked during the cycle.
7. When the “cycle complete” message appears, touch the unlock
symbol and unload.

Replacing HIP Cleaning Solution
When the “no detergent” message appears, the HIP cleaning solution
box needs to be changed (part-number CS-HIPL).
Cleaning the Filter
If there is debris on the filter,
remove it, rinse under a tap
and replace. Ensure that
the filter is firmly in position.
Cleaning the Wash Arms
If the wash arms are not turning
easily, remove them, rinse under
a tap and reassemble. To remove
the upper or middle arm, unscrew
the collar counter clockwise. To
remove the lower arm, unscrew
the collar clockwise.
Refilling the Water Softening Salt (if used)
When the message “salt level low” appears the salt needs to be refilled.
Unscrew the salt container lid. Add 1 kg / 2.2 lbs of salt. Replace the lid
and ensure that it is tight. Run a complete cycle with no instruments.
Wash arms
Filter Salt container

CF1 Water
Heating failure
CF2 Chamber
Filling Failure
CF3 Chamber
temperature
reading failure
CF4 Draining
failure
CF9 Software or
PCB Failure
CF11 No
detergent
CF14 Fault
Flow Switch
CF15 Chamber
overflow
Error Cause Solution
The water does not reach
the required temperature in
the specified time
The water does not fill
the chamber within the
specified time.
Faulty sensor.
Water cannot drain
from the unit.
Cycle length is more than
2hr 30 min.
Flow switch did not detect
detergent during wash
phase.
Flow switch is stuck closed.
Overflow switch did not turn
off after 30 sec of running
the drain pump.
Call for service.
Check that the water
hoses are not kinked.
Open the water shut-off
valves.
Call for service.
Check that the drain
hose is not kinked.
Check that the filter in
the bottom of the chamber
is not obstructed.
Call for service.
Replace detergent box
if empty.
If the problem persists,
Call for service.
Call for service.
Check if drain is blocked;
Call for service.
Error Messages