SCORPION ERS 2 User manual

ERS 2 POINT PHONE INSTALLATION
INSTRUCTIONS
Tel: [phone]
scorpionsp.com
[email protected]
1. Insert the blue key into the axle of the Scorpion
(green dot side) and rotate counter-clockwise to expand
the legs wide enough for the device fits into the
Scorpion.
3. Place the device into the Scorpion and ensure that
the leveling plate is aligned in the center of the
device.
4. Press firmly on the front of the device to ensure the
dual lock and leveling plate fully adheres to the device.
5. Tighten the side legs of the Scorpion until they
slightly touch the side of the device by inserting the
blue key into the axle (green dot side) and rotate
clockwise.
2. Remove the 3M adhesive covering.
6. Raise the leveling plate by inserting the blue key into
the leveling plate studs. Switch back and fourth
between the studs to ensure equal pressure.
7. After Securing leveling plate, go back and tighten
side legs. There will no longer be a gap between the
screen and legs when leveling plate has been
properly raised.
NOTE: Do not over tighten
NOTE: 3 turns and switch until plate is raised
*IMPORTANT* PLEASE READ BEFORE INSTALLING
Before installing, use supplied blue key to unlock
Scorpion axle. Unlock by turning counter clockwise.

9. Feed the charging cable through before attaching
Scorpion to the base.
10. Place the installed device into the receiver. Press
the lock in to secure. Scorpion should now be locked
into place.
8. To lock axle, insert the blue key into the center of
the Scorpion Body located on the back side of the
device. Turn the blue key clockwise to tighten the
screw and lock the axle into place.
IMPORTANT
Do not over tighten the leveling plate. If you
see a bump or bubble in the screen, or bend
in the device, the leveling plates are over
tightened. Please refrain from over tightening
as this may damage the device.
*IMPORTANT* MUST LOCK AXLE TO FULLY SECURE