Getting Started DOLPHIN Battery Use
When you buy the
SEA-DOO®SEASCOOTER™
DOLPHIN
the battery is disconnected and needs to be charged,
follow the instructions on page 5, Battery Use, Charging
the Battery, for charging and connection.
Using the SEASCOOTER™for swimming and snorkeling.
To use the SEASCOOTER™for swimming or snorkeling
follow these instructions.
1. Charge the battery - see page 6 for instructions.
2. Place the SEA-DOO®SEASCOOTER™DOLPHIN into the
water.
3. When ready to set off, switch the Safety Lock to the
On position shown in fig. 2a.
4. Pull and hold both Triggers to start the Propeller.
(There is a short delay before the Propeller begins to
rotate).
5.
To stop the Propeller, simply release one or both
trigger(s).
6. Always set the Safety Lock to the Off position when
out of the water - see fig. 2b .
4 5
Fig.2b
CAUTION
• The Battery Housing should always be ventilated
during charging to allow potentially explosive
gasses to dissipate. Before removing/attaching any
battery cables always allow two minutes for any
gasses to dissipate.
• ALWAYS connect charger jack to the battery first
and then plug the charger into the mains. When
charging is complete, unplug the charger from the
mains first and then from the battery.
•
ALWAYS ensure the charger is DRY before
plugging it into a live socket.
• NEVER place the battery in a sealed container
when charging.
• Never charge battery near water.
• If in doubt of the state of the battery, recharge it
until the indicator on the battery charger indicates
a full charge.
• ALWAYS charge battery in a well-ventilated place
where unit is out of reach of children.
• ALWAYS ensure the unit is dried thoroughly before
opening the Nose Cone for charging or changing
the battery.
Fig.2a
On Position
Off Position
