Seastar Solutions pro-trim PT1000 User manual

©2013 Marine Acquisition (US) Inc.
These Instructions describe how to replace the toggle switch in the PROTRIM® Single or Dual Bezel Switch
Performance Tilt and Sea Star® Hydraulic Helms.
Step 1. Remove the plastic cover of the switch
with boot (counterclockwise). Then remove the
face nut, and then the plastic cover (see parts
list diagram, Figure 1).
Step 2. Remove the hex nut holding the switch
in place. Remove switch. Disconnect wires and
reattach to new switch one at a time (red to
center terminal, green to top and blue to
bottom terminal).
Step 3. Mount switch with hex nut.
Step 4. Reinstall the cover, face nut, and
operation lever with boot on the switch
assembly.
Manual # IS-CA76431-1

TESTING THE INSTALLATION
FINAL ADJUSTMENTS
Test ProTrim™to make sure it performs properly and the engine moves in the direction you expect when the
switch is activated in either direction. Pushing the lever up should make the engine move upward. Pushing
the lever down should make the engine move down. A test of the original trim switches should also be done
at this time. If all systems work properly, make a nal inspection of the wiring connections and wrap them
with a good quality electrical tape.
Install the appropriate decal(s) as shown in
Figure 2 (be sure plastic switch cover(s) is(are)
clean and dust-free. Install the steering wheel,
using the woodruff key and lock nut that was
removed with the wheel. With the seat (and
wheel position, if equipped with tilt) adjusted
properly, try activating the switch from a normal
driving grip. If the lever seems too close or too
far from the steering wheel rim, this can be
adjusted to suit the driver’s taste. By bending
this bracket slightly, the lever can be moved
closer to or farther from the rim of the steering
wheel.
We recommend that the driver operate
ProTrim™ for some time without adjusting this
bracket until he or she has determined to most
suitable lever distance.
FIGURE 2