Security Brands RTE 300 Series User manual

QUICK START GUIDE RTE 300 1 of 2
Model 14-RTE300
2Make sure you have everything shown here. (Screwdriver not shown)
START HERE
1Carefully unpack box.
What’s what?
Important components labeled
RTE Unit Faceplate (Back)
Internal wiring not shown for clarity.
9-V Battery
Must be installed before use
Key Switch
For enabling and disabling unit
(Unit is disabled as shown)
Exit Button
Triggers gate/door to open
Lock
For securing interior of RTE unit
Dip Switches
For pairing RTE unit to receiver
RTE Unit 9-V Battery Lock Key Carriage Bolt
( 4x )
Hex Nut
( 4x )
Hole PlugKey Switch Keys
3Unlock and remove faceplate
of RTE unit; then using
carriage bolts and hex nuts,
attach to pedestal as shown.
WARNING!
AUTOMATIC GATES CAN CAUSE
SERIOUS INJURY OR DEATH!
ALWAYS CHECK that the GATE PATH IS
CLEAR BEFORE OPERATING!
REVERSING or other SAFETY DEVICES
SHOULD ALWAYS BE USED!

RTE Unit Faceplate (Front)
Reset Button
For performing reset procedures

NEED HELP Call [phone]
Email [email protected]
We are available Mon–Fri / 8am–5pm Central
© 2020 Security Brands, Inc. All rights reserved. QSG-14RTE300-EN Rev. A (5/2020)
2 of 2
Model 14-RTE300
QUICK START GUIDE RTE 300
6Make sure gate/door path is clear;
then press exit button on RTE unit
and confirm gate/door opens.
(If nothing happens, go back to Step 5)
4Locate receiver (not included) and
open for access to DIP switches.
NOTE: For a gate installation, the receiver is typically
installed inside the gate operator housing. NOTE: Key switch must be in the “enabled” position.
1234567890ON
123456
OPEN
78910
RTE Unit DIP Switches
Receiver DIP Switches
(look of components may vary)
5Carry RTE unit to receiver; then set DIP switches on RTE unit to
match DIP switches on receiver. Double check for match.
1 2 3 4 5 6 7 8 9 0/10
Unit Enabled
(exit button active)
Unit Disabled
(exit button inactive)
AThe RTE unit can be disabled or enabled at any time using the
key switch located below the exit button.
NOTE: Use the blanks above to note positions. Use an “X” for ON and leave blank for OFF.
DIP switches may be labeled differently. The word, OPEN, means the same thing as OFF.
Your system is ready to use.
INSTALLATION COMPLETE!
N
IMPORTANT!
r
The RTE 300 is compatible ONLY with
300-MHz RECEIVERS that use
10 DIP SWITCHES, including those with
the Digi-Code or Multi-Code®brands.
This unit WILL NOT WORK with any
other receivers!
If you are not sure what kind of receiver
you have, check with your distributor.