Seima Limni 135 User manual

seima.com.au limni-135-in | v 1.0 | page 1 of 2
Important — read this first!
1Inspect the bath before installation, to ensure there are no visible defects. If a defect is found, do not install the bath and contact
the supplier immediately. Claims for defects will not be accepted after the product has been installed.
2The bath must be installed by a licensed tradesperson. Failure to do so may void the warranty.
3Compliance with AS.3740 Waterproofing of Wet Areas within Residential Buildings applies when installing baths.
4Local authorities may have specific installation requirements and this should be checked before installation.
5Grade the bath sub-floor in accordance with requirements of local authorities. Grade sub-floor 1:60 minimum.
6The protective film on the bath should be left intact during installation and should remain on the bath until first use.
Base support for the bath
1The design of acrylic baths allows the base of the bath to be supported by three timber support battens.
2Position and fix timber support battens to the base of the bath and the floor, using a suitable floor and wall panelling adhesive.
Ensure that the bath is neatly fitted and properly supported.
3During installation, use a spirit level to check that the bath rim is level.
timber support battens
Ensure that the rim of the bath is level, using a spirit level.
Installation Guide
Limni 135 Island Bath
Protective film | Care and maintenance of the bath surface
1There is a protective film on the acrylic surface of the bath at the time of purchase. This should remain intact until the bath is ready
to use to protect the bath during installation.
2To preserve its polished finish, this bath should be cleaned with a soft cloth using warm, soapy water or household detergent.
Do not use abrasive cleaning products.
3If accidental scratches, abrasions or burns occur, the surface finish can be restored by gentle polishing with Brasso.
4For full warranty terms and conditions, please visit seima.com.au
Please leave this guide
with the end user.
Please note
−All measurements are in millimetres.
−Dimensions are nominal and subject to normal ceramic manufacturing variations of ±5mm.
−Fixing: Use acetic cured silicone sealant. Do not use epoxy type adhesives.
−Specifications may vary without notice as part of our continuous improvement practices.
−Clean with a damp cloth. Do not use abrasive cleaners, liquids or pastes.

seima.com.au
Island installation
1See diagram below — there is a ledge between the wall and the side of the bath.
The minimum setout from the wall is 75mm. Refer to the local authority for local setout requirements.
2Ensure that the area under the bath is ventilated in accordance with local requirements.
page 2 of 2
compressed cement
fibre sheet backing
tiling
sealant
fill
water stop
suitable moisture barrier
standard 40mm
waste outlet
unfinished
floor
run-off tube
tiles
sealant
grade sub-floor
1:60 minimum (or
local requirement)
wall
Please note
−All measurements are in millimetres.
−Dimensions are nominal and subject to normal ceramic manufacturing variations of ±5mm.
−Fixing: Use acetic cured silicone sealant. Do not use epoxy type adhesives.
−Specifications may vary without notice as part of our continuous improvement practices.
−Clean with a damp cloth. Do not use abrasive cleaners, liquids or pastes.