SEMAK PW50 Installation and operation manual

SEMAK PIE WARMER –MODELS PW50/PW50B &PW100/PW100B
SEMAK AUSTRALIA:FACTORY 18, 87-91 HALLAM SOUTH ROAD,HALLAM VIC 3803
PH [phone] FAX [phone] WEB WWW.SEMAK.COM.AU
OPERATION AND WARRANTY BOOKLET
PW50 PW50B

Page | 2
Table of Contents
General Safety Instructions for All Semak Products ..................................................... 4
Safety Instructions........................................................................................................ 5
Operating Instructions for the Semak Pie Warmer....................................................... 6
Cleaning Instructions for the Semak Pie Warmer ......................................................... 7
Spare Parts for the Semak Pie Warmer ........................................................................ 7
Service & Maintenance ................................................................................................ 8
Electrical Compliance ................................................................................................... 8
Warranty ...................................................................................................................... 8
WARRANTY REGISTRATION ........................................................................................ 10

Page | 3
RETAIN THESE SAFETY INSTRUCTIONS

Page | 4
General Safety Instructions for All Semak Products
Do not use the appliance for other than its intended use.
Never leave the appliance unattended when in use.
The appliance should not be used by children or infirm persons and close
supervision is necessary when used near such persons.
Always switch off at power outlet before removing the plug. Remove by holding
the plug –do not pull the cord.
When the appliance is not in use, or prior to cleaning, always switch off the
power and remove the plug.
To avoid the risk of electric shock, do not immerse the plug, cord or any part of
the appliance in water or any other liquid.
Do not use near a stove or heat source and do not let the cord come in contact
with any hot surface.
Do not use the appliance with an extension cord unless that cord has been
checked and tested by a qualified technician or if it is an extension cord that has
been manufactured by a reliable electrical goods manufacturer and has not
been altered in any way.
Do not operate any appliance with a damaged cord or plug, or after the
appliance malfunctions or has been dropped or damaged in anyway. Return to
Semak or an authorised service agent for repair.
CAUTION Hot Surfaces.
NEVER leave the appliance ON unattended. ALWAYS unplug the cooker after
use.

Page | 5
Safety Instructions
Only use the appliance on a flat, level and stable surface. DO NOT use on a wet
surface.
When in operation the appliance surfaces are hot. DO NOT touch the sides or glass
of the cabinet while the appliance is in operation. Open glass doors and gain
access to the cabinet using the handles on the doors.
Shelves should be adjusted prior to operation. If adjustment is required while the
appliance is operating, an oven mit or similar heat protection glove should be used
to prevent skin burns.
DO NOT touch the heating element while the machine is in operation.
ALWAYS turn off the appliance and allow it to cool down before cleaning.
Use a barely damp cloth to wipe the machine once it has cooled.
Remove glass panels, shelves and crumb tray for cleaning. DO NOT place hot glass
panels in cold water as they may shatter.
DO NOT hose out the inside of the machine. Wipe the interior with a damp cloth.
DO NOT use caustic substances to clean the warmer and do not allow caustic
substances to make contact with any electrical components of the warmer.

Page | 6
Operating Instructions for the Semak Pie Warmer
1. Make sure that the knob is in the “OFF” position. is in the off position.
2. Plug into an earthed 240V AC power supply.
3. Turn the switch knob on the warmer until the dial reaches high for maximum
heat.
4. When warmer reaches the desired temperature (see the temperature gauge)
turns the knob to the desired temperature.
5. Place foodstuffs in a preheated oven. Foodstuffs should be maintained at 60ºC
to prevent bacterial spoiling. ( The failure to meet proper food-handling
standards may result in food poisoning and prosecution.)
6. Foods that are placed in the warmer in a frozen state require longer in the oven
to reach the desired temperature than those placed in the oven when at room
temperature.
7. Care should be taken to ensure that the food has reached the correct
temperature on the inside. The food warmer is also an oven capable of heating
and cooking food. It is possible for foodstuffs to reach 110ºC and hence the
contents of e.g. pies to become scalding hot. Great care should be taken to
ensure the food is properly heated and stored.
8. Uncooked or raw foodstuffs should be separated from cooked food to prevent
cross-contamination. A system of food rotation will minimize the risks of this
problem.
9. A small dish of water may be used as a humidifier to prevent food drying too
rapidly. Do not allow the dish or water to come in contact with the heating
element. It may be necessary to replenish the liquid several times during
operation.
10. DO NOT run the warmer when empty. The heating capacity of the oven will
vary depending on the quantity of foodstuffs within. Adjustment to the heat
settings may be necessary as quantities vary.
11. When finished heating turn the knob to the “Off” position.
12. Remove crumb tray, empty and clean. Remove trays and wipe over with a
damp cloth.
13. Paper bags should not be placed in the oven. If however, they are placed in the
oven they should not come into contact with the element. Extreme care and
close supervision is required at all times in this situation.
14. NEVER leave the warmer on unattended. ALWAYS unplug the warmer after use.

Page | 7
Cleaning Instructions for the Semak Pie Warmer
1. ALWAYS turn off the appliance and allow it to cool down before cleaning.
2. Use a barely damp cloth to wipe the machine once it has cooled.
3. Remove glass panels, shelves and crumb tray for cleaning. DO NOT place hot
glass panels in cold water as they may shatter.
4. DO NOT hose out the inside of the machine. Wipe the interior with a damp
cloth.
5. DO NOT use caustic substances to clean the warmer and do not allow caustic
substances to make contact with any electrical components of the warmer.
6. Ensure that all parts of the warmer are properly dried before replacing them in
the appliance.
Spare Parts for the Semak Pie Warmer
Part Number
Description
Part Number
Description
50010
50020
50030
50040
50050
50060
50070
50080
50090
50100
Element suit 50 capacity
Element suit 100 capacity
Heat Control
Heat Control Knob
Door Handle
Glass Door 50 capacity
Glass Door 100 capacity
Crumb Tray 50 capacity
Crumb Tray 100 capacity
Wire Rack 50 capacity
50110
50120
50130
50140
50150
50260
50270
50280
50290
Wire Rack 100 capacity
Temperature Gauge
Lead & Plug
Glass Rear 50 Capacity
Glass Rear 100 Capacity
SS Door 50 Capacity
SS Door 100 Capacity
SS Rear Panel 50 Capacity
SS Rear Panel 100 Capacity
Spare Parts, exploded views and wiring diagrams are available from our webpage. Go
to www.semak.com.au and locate the appliance in the product section for the above
information.

Page | 8
Service & Maintenance
The Semak Pie Warmer does not contain user-serviceable parts. For Service and
Repair, contact Semak for your nearest Authorised Service Agent
The Foodservice Industry is deemed a hostile environment within the scope of
AS/NZS 3760:2003. Semak Pie Warmer MUST be routinely electrically tested for
compliance with this standard if used commercially.
It is recommended that a Food Safety program such as HACCP be employed and that
routine service and repair be undertaken at the time of electrical testing to ensure
the correct operation and function of all parts.
Electrical Compliance
Semak Pie Warmers comply with the following electrical standards
CISPR 14
Warranty
The Semak Pie Warmer is a Commercial appliance. This product is guaranteed for 1
Year* from the date of purchase against mechanical and electrical defects. If the fault
is deemed caused by MISUSE/ABUSE the terms of the warranty are invalidated. If the
product has been opened or tampered with (ie. In an attempt to repair it) the
warranty is invalidated. All warranty repairs should be undertaken by Dimark
Commercial Pty. Ltd.
It is against company policy to authorize warranty repairs over the phone. Service
Agents will require a work order number from Semak to conduct warranty repairs.
*Warranty excludes Elements

Page | 9
SEMAKWARRANTY
THIS WARRANTY APPLIES ONLY TO PRODUCTS MANUFACTURED AND SOLD IN AUSTRALIA
The benefits conferred by this warranty are an alternative to all other rights and remedies
in respect of the product which the consumer has under the Trade Practices Act and similar
State and Territory Laws.
Semak Australia. Warrant each new SEMAK appliance manufactured by SEMAK to be free
from defects in materials or manufacturing process for a period of 2 years from the date of
original purchase.
Should defects due to faulty materials or manufacturing process develop within the
warranty period, the appliance will be repaired without charge providing all conditions of
this warranty are observed.
1. Proof of Purchase and Warranty card must be retained and available on request.
2. This Warranty is void if the equipment has been damaged due to misuses neglect or is
used for a purpose for which it was not suited; and no repairs, alterations or
modifications have been attempted by other than Semak or its authorised Service
Agent.
3. Semak Australia. Reserves the right to reject a claim for warranty if service is required
due to misapplication, improper installation, inadequate wiring, and incorrect voltage
conditions. Under no circumstances shall SEMAK or its agents bear responsibility for
consequential damages of any kind.
4. Where required by Statute or local authority, equipment must be installed by qualified
person in accordance with all relevant regulations. Failure to do this will void product
warranty.
5. Cost of transport of any appliance or part to and from SEMAK or its Service Agent is to
be paid by the owner.
6. A charge will be made where failure is due to neglect, abuse or accidental damage on
the part of the operator, or when no fault can be found or the fault is due to causes
outside the control of Semak Australia.
7. The above does not preclude the purchaser from their Statutory rights as a consumer.
Semak Australia
Factory 18
87-91 Hallam South Road
HALLAM VIC 3803
Ph 61 3 9796 4583
Fax [phone]
Email techn[email protected].au

Page | 10
WARRANTY REGISTRATION
Retain for Future Reference
DO NOT SEND
Please complete one registration for each Semak appliance.
You may be required to provide this information when requesting after sales service. Please
staple your proof of purchase to this page.
Company Name: ________________________________________________
Company Address: ________________________________________________
Business Type: ________________________________________________
Contact: ________________________________________________
Phone: ________________________________________________
Fax: ________________________________________________
Email: ________________________________________________
Product: ________________________________________________
Serial Number: ________________________________________________
Date of Purchase: ________________________________________________
Place of Purchase: ________________________________________________