Sena Prism Tube User manual

PREPARATION
Getting to Know the Prism Tube Layout
Camera
Lens Cap
Lens
Slide Switch
SD Card Format Button
DC Power Charging &
Firmware Upgrade Port
Status LED
Rear Cap
Fault Reset
Pin-hole Button
MicroSD Card
Slot
Speaker and Microphone
Speaker
Wired
Microphone
Hook and Loop
Fastener for Speaker
Rear Cap for USB Cable
USB Cable for Speaker &
Microphone
Hook and Loop Fastener
for Wired Microphone
Installing the Prism Tube System
Connecting the Speaker
1 42 3
Note Connect the speaker cable to the USB cable’s black connector.
Mounting
Clamp Unit Camera
1
2
1
2
3
12
BASIC OPERATION
Turning the Camera On or O
To Turn On the Camera and Start Recording
ON
“Camera on”, “Recording”
To Turn O the Camera and Stop Recording
OFF
“Camera o”
Note • Recording will start shortly after the camera is turned on. Recording stops
shortly before the camera is turned o.
• A microSD card must be inserted to record video.
Adjusting the Angle Speaker
12 3
12
Note • The tube swivel mount wheel must be fully tightened after adjusting the
camera angle.
• Make sure the tip of the slide switch faces upwards and is parallel to the
ground.
• You can use the glued surface mounting plate to attach the clamp unit to
the surface of the helmet. Full adhesion is achieved after 24 hours.
Connecting the Wired Microphone
1
2
To record your voice more clearly, connect the wired microphone.
Note • Connect the wired microphone cable to the USB cable’s red connector.
• The camera’s internal microphone automatically turns on when the wired
microphone is disconnected.
Others
Clamp Unit Tube Swivel Mount
Glued Surface Mounting Plate USB Power & Data Cable
Allen Wrench
Inserting a MicroSD Card
1 2 3
Note Optional microSD cards up to 32 GB are compatible with the PrismTube.

Quick Start Guide
Action Camera for Motorcycle Helmet
DATE AND TIME SETTING
To set the date and time of the camera, follow the directions below.
1. Turn o the camera and connect it to your PC via a USB cable.
2. Create a blank text le (.txt) with a name “timeset.txt” in the root folder of the
camera.
3. Disconnect the camera from your PC and restart the camera. The camera will
automatically take the date and time at which the text le was created.
TROUBLESHOOTING
Memory Card
When Memory is Full
“Memory is full”
Formatting the Memory Card
To format the memory card, press the SD card format button while the camera is
turned on.
Fault Reset
If the Prism Tube is not working properly for any reason, push the pin-hole reset
button located on the back of the camera while it is turned on.
Sena Technologies, Inc.
www.sena.com
Customer Support: support.sena.com
E-mail: [email protected]
15.Nov
You can view other Sena products at the
Sena website: www.sena.com.
BATTERY
Checking the Battery Level
Blinking
70~100%
Blinking
30~70%
Blinking
0~30%
Turn on the camera and check the battery level via the Status LED.
Low Battery Warning
“Battery low”
Charging the Battery
Charging
Fully charged
AC adapter
or
TRANSFER
Transferring Video Files
Note Turn o the camera and connect it to your PC via a USB cable.Your PC
should recognize the camera as a removable device.
FIRMWARE UPGRADE
To install the latest rmware of the camera, follow the directions below.
1. Turn o the camera and connect it to your PC via a USB cable.
2. Download the latest rmware from www.sena.com.
3. Move the downloaded rmware le into the root folder of the camera.
4. Disconnect the camera from your PC and restart the camera. The rmware
will be installed automatically.