SENAO IAP8250AG User manual

IAP8250AG
Page 1
IAP8250AG/IAP8251AG
Installation Guide
Indoor Enterprise AP
V. 0.2
PRODUCT DESCRIPTION
IAP8250AG is Senao new generation of Enterprise AP with 4x4 MU-MIMO technology
implement. It is using Qualcomm total solution to provide the maximum throughput
on the WIFI.
IAP8250AG is internal antenna model.
IAP8251AG is external antenna model.
Any installation to IAP8250AG applies to both models.
▌PACKAGE CONTENT
!IAP8250AG or IAP8251AG Access Point
!IAP8250AG/IAP8251AG Quick Start Guidet
!Mounting Bracket
!12VDC Power Supply

IAP8250AG
Page 2
!Mounnting screw kits (includes washers, wall anchors and bolts)
!5G Diople antennas
!2.4G Diople antenna
▌CONNECT TO THE IAP8250AG/IAP8251AG ACCESS POINT
1. Attach and gently tighten the provided antennas to the appropriate port on the IAP8251AG
2. Power is provided through two Ethernet ports (LAN port). This is the preferred method of powering the
AP on ceiling and wall installations
3. The IAP8250AG can also be powered by an external DC power supply plugged into an AC source. Plug
the supply’s input jack into the DC-In port

IAP8250AG
Page 3
▌MOUNTING OF THE IAP8250AG/IAP8251AG ACCESS POINT
TOOL-LESS CEILING MOUNT

IAP8250AG
Page 4
FLAT WALL OR SOLID CEILING MOUNTING
Mounting(the(AP(with(4(drill(holes(into(flat(wall(or(solid(ceiling(mounting.(

IAP8250AG
Page 5
FCC Statement:
Federal'Communication'Commission'Interference'
Statement' '
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible
for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any

IAP8250AG
Page 6
interference received, including interference that may cause undesired operation.
For product available in the USA/Canada market, only channel 1~11 can
be operated. Selection of other channels is not possible.
This device and it's antennas(s) must not be co-located or operating in conjunction with any other
antenna or transmitter except in accordance with FCC multi-transmitter product procedures.
This device is restricted for indoor use.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 25
cm between the radiator & your body.