SENAPTEC STROBE User manual

SENAPTEC STROBE
REACTION TRAINING EYEWEAR
8
TM

The SENAPTEC STROBE is performance training eyewear designed to train the
connections between an individual's eyes, brain, and body. Using liquid crystal technol-
ogy, the lenses icker between clear and opaque, removing visual information and
forcing the individual to process more eciently. The Senaptec Strobe can be integrat-
ed into existing training drills and exercises.
The SENAPTEC STROBE will intentionally obscure one's vision to train reaction and
response. As a result, allow for adequate amount of space when training. Be sure there
are no objects in the training space which could cause a user to trip, or cause injury if
struck while moving. In addition, be sure that you are in an environment where no
objects or persons could enter the training space, as such objects could collide with the
user and cause serious injury or death.
INTRODUCTION
SENAPTEC STROBE is not sunglasses. STROBE lenses do not provide UV protection.
Do not expose SENAPTEC STROBE to extreme environmental conditions.
Do not expose SENAPTEC STROBE to driving rain, hard water spray or immersion in water.
Do not wear SENAPTEC STROBE while operating a vehicle or heavy machinery of any
type, participating in any contact sport, or participating in any activity where an object
could collide with the user.

ADJUST DIFFICULTY
A
12345678
B C
both lenses
strobing
left lens
strobing
right lens
strobing
8
ADJUST MODE
TURN ON
Press M
3 sec.
TURN OFF
8
easiest most
dicult

FIT ADJUSTMENT
Slide the strap buckle to adjust for t
The Senaptec Strobe comes with
an alternate size nose piece to
provide a dierent t. Simply pull
o the nose piece and replace.

CHARGING
The micro USB connection plugs into the
SENAPTEC STROBE directly under the logo.
Keep USB port covered when not charging.
The USB charging cable can be plugged into
a computer USB port or an outlet.
Battery indicator will show full when
the SENAPTEC STROBE is fully charged.
8

CLEANING
Clean the lenses with a micro-ber cloth. Separate
the strap from eyewear before washing strap.
Do not use cleaning products on lens.
Hand-wash strap in water.

2.|4.
3.
x5
with
eyewear
20’ / 7m
x5
without
eyewear
TRAINING DRILLS AVAILABLE ON SENAPTEC.COM/STROBETRAINING
EXAMPLE: Ball Catch Drill
1.
SET MODE
SET LEVEL
8
1. Set Level and mode
2. First catch without eyewear
3. Then catch with eyewear
4. Then again without eyewear
5. Adjust level as desired and repeat

IMPORTANT SAFETY INFORMATION
Read all safety and user instructions before training with
SENAPTEC STROBE.
NOTICE: THIS IS NOT A MEDICAL DEVICE. The Senaptec Strobe
should not be used to diagnose, treat, or prevent any disease or
medical condition. If you are experiencing any physical or
mental abnormality or symptom, including but not limited to a
change in your vision, discomfort related to your vision,
headaches, or any other symptom relating to your head or eyes
in any way whatsoever, you should immediately consult your
doctor and NOT USE THIS DEVICE until a medical professional
has deemed it appropriate.
WARNING: DO NOT USE IF YOU ARE PRONE TO SEIZURES,
BLACKOUTS, or believe that you may be prone to seizures or
blackouts. Discontinue use IMMEDIATELY and consult a
physician if you experience any of the following: convulsion,
eye or muscle twitching, loss of awareness, involuntary
movements, dizziness, or disorientation.
WARNING: DO NOT USE UNDER THE INFLUENCE OF ANY DRUG
OR ALCOHOL.
WARNING: SENAPTEC STROBE is not sunglasses. STROBE lenses
do not provide UV protection.
WARNING: The SENAPTEC STROBE will intentionally obscure
one's vision to train reaction and response. As a result, do not
wear or use SENAPTEC STROBE outside of a protected and safe
environment that is designed and kept for the sole purpose of
performing training drills in a controlled setting. Use in any
other environment could lead to serious injury or death. USE
ONLY AS DIRECTED.
Failure to follow these instructions could result in serious injury
or death.
This device complies with Part 18 of the FCC rules.
PROPER USE OF SENAPTEC STROBE
Allow for adequate amount of space when training. Be sure
there are no objects in the training space which could cause a
user to trip, or cause injury if struck while moving. In addition,
be sure that you are in an environment where no objects or
persons could enter the training space, as such objects could
collide with the user and cause serious injury or death.
EXAMPLES OF MISUSE
The following activities constitute misuse of this product and
should not be performed under any circumstances.
Do not drop, crush, puncture, burn, or force open SENAPTEC
STROBE.
Do not expose SENAPTEC STROBE to extreme environmental
conditions, including temperatures over 122°F (50°C), or under
32°F (0°C), environments with abnormal humidity or dust. Do
not expose SENAPTEC STROBE to driving rain, hard water spray
or immersion in water.
Other than charging the battery, do not attempt to repair
SENAPTEC STROBE yourself.
Do not wear SENAPTEC STROBE outside of a protected training
environment that is designed to provide a safe setting whereby
a user can experience limited visibility for training purposes.
Under no circumstances should you wear SENAPTEC STROBE
while driving a car, riding a motorcycle or ATV, riding a
snowmobile, operating heavy machinery of any type, ying a
plane, ying a helicopter, swimming, riding a bike, skateboard-
ing, rollerblading, roller skating, snowboarding, skiing,
participating in any contact sport, participating in any activity
where an object could collide with the user causing injury
including, but not limited to, batting a baseball or softball
using a live pitcher.

IMPORTANT HANDLING INFORMATION
Read the following information before using the SENAPTEC STROBE. This page contains critical and essential information relating to
use of the Senaptec Strobe, its corresponding warranty, and Senaptec’s liability for any damages relating to the Senaptec Strobe.
NOTICE: Failure to follow these handling instructions could damage SENAPTEC STROBE and void any warranty or return policy
oered by Senaptec.
Always store SENAPTEC STROBE in the hard case provided when not in use.
SENAPTEC STROBE should be stored and used within acceptable temperatures 32-122°F (0-50°C), Do not leave SENAPTEC STROBE
in your car as temperature may exceed 122°F (50°C).
Clean the SENAPTEC STROBE lens using the micro-ber cleaning cloth or other soft cloth. Be sure cleaning cloth is clean and free of
any lint or debris. Wipe lens lightly to remove any dirt or smudges. Do not use cleaning products on lens.
SENAPTEC STR0BE must be disposed of properly according to local laws and regulations.
ONE YEAR LIMITED WARRANTY
Your Senaptec product is warranted to be free of defects in materials or workmanship, under normal use, for a period of one year
from the date of purchase. This limited warranty excludes damage resulting from improper care or handling, accidents,
modication, unauthorized repairs, normal wear, or other causes which are not defects in materials and workmanship, lf your
product is defective, return it and the store receipt to the place of purchase. lf there is a covered defect, Senaptec will replace the
product (subject to availability) or issue a refund. We reserve the right to refuse either replacement or refund (but not both) if the
cost of doing so would be disproportionate to the defect.
THE ABOVE-DISCUSSED LIMITED WARRANTY IS IN PLACE OF ALL OTHER EXPRESS AND IMPLIED WARRANTIES OF ANY KIND, WHICH
ARE HEREBY EXPRESSLY DISCLAIMED AND RENDERED OF NO FORCE AND EFFECT INCLUDING, BUT NOT LIMITED TO THE IMPLIED
WARRANTY OF MERCHANTABILITY, NON-INFRINGEMENT AND FITNESS FOR ANY PARTICULAR PURPOSE. SENAPTEC’S SOLE
OBLIGATION AND LIABILITY FOR PRODUCT DEFECTS SHALL BE, AT SENAPTEC’S OPTION, TO REPLACE SUCH DEFECTIVE PRODUCT
OR REFUD TO BEERY THE AMOUNT PAID BY BUYER THEREFORE.
IN NO EVENT SHALL SENAPTEC BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, PUNITIVE, EXMPLARY, OR CONSEQUENTIAL
DAMAGES ARISING OUT OF OR RELATING TO ANY SENAPTEC PRODUCT OR SERVICE, INCLUDING WITHOUT LIMITATION ANY AND
ALL LIABILITY FOR LOST PROFITS, LOST SAVINGS, OR LOSS OF BUSINESS OPPORTUNITY. BUYER AND/OR USER EXPRESSLY AGREE
THAT ANY RECOVERY IS LIMITED TO THE PURCHASE PRICE. IN NO EVENT SHALL SENAPTEC’S LIABILITY EXCEED THE BUYER’S
PURCHASE PRICE FOR THE SENAPTEC STROBE. No other person or company is authorized to change this limited warranty, and your
dealer is solely responsible for any other warranties.
The foregoing is without prejudice to other legal rights that may arise under applicable national legislation.
The Senaptec warranty extends only to products purchased from an authorized Senaptec distributor. The warranty does not apply
to consumable parts, such as batteries unless damage had occurred due to defect in materials or workmanship.
If you do not accept any of the foregoing information, do not use the SENAPTEC STROBE. If you have any questions regarding the
foregoing information please contact Senaptec at: [email protected].

www.senaptec.com