ServoCity SPT100 Series User manual

SPT100 Direct Drive Pan & Tilt Mount
Please review the following before you assemble your Tilt Mount
● Read the instructions before you begin assembly, and familiarize yourself with the parts in-
Make sure your kit includes the following
Tools needed:
Phillips Head Screwdriver
This kit will work with any standard size Hitec or Futaba servos. We will be using the Hitec HS-475HB servo in the
instructions. Steps or procedures may vary slightly depending on the servo you choose.
1. Attach a servo horn to the
plate shown above using (4) of
the #2 x 3/8” screws. The out-
er holes are not symmetric so
you may need to rotate the
plate for the holes to align.
2. Bottom of the plate with
the servo horn attached.
Smooth side against the
servo horn.
3. Using (4) of the #2x3/8”
screws attach the remain-
ing servo horn to the plate
shown above. The outer
holes are not symmetric so
you may need to rotate the
plate for the holes to align.
4. Bottom of the side plate
with the servo horn attached.
Smooth side against the servo
horn.
5. Using the (2) #4x1/2”
black flat head plastic
screws attach the top plate
with the smooth side down.
6. Attach the servo mounts
using the (2) #4x1/2” black
plastic screws as shown
above. Do not fully
tighten!
7. Servo mounts attached.
These should be left loose
until the tilt servo is
attached.
Copyright 2016 Robotzone, LLC.— All Rights Reserved
OVER►
(3) ABS Plates
(8) #2x3/8” Phillips Head Plastic Screws
(2) #4x1/2” Black Phillips Head Plastic Screws
(4) #4x3/8” Truss Head Plastic Screws
(2) #4x1/2” Black Phillips Flat Head Plastic
Screws
(2) Hitec (or Futaba) “X” Horns

8. Using your controller, set
the pan servo to neutral and
then bolt the plate to the servo
as shown above using the
factory servo screw.
9. Using the (4) #4x3/8” black
truss head screws install the
tilt servo and tighten the loose
servo mount screws from step
#6.
10. Using your controller, set
the tilt servo to neutral and
then attach the plate as shown
above using the factory servo
screw.
11. Your unit is now complete and ready to use.
Copyright 2013 Robotzone, LLC.— All Rights Reserved