Seville Classics UltraShield WEB657 User manual

Customer Service Informaon
Telephone: [phone]
Fax: [phone]
Hours: 8:30 AM – 4:30 PM (PST)
Email: Suppor[email protected]
Homepage: www.SevilleClassics.com
102020
Step 6.
Remove plasc from feet and stand
UltraShield® upright.
Remove the bags to nish.
Care Instrucons
Clean with mild soap and water. Dry with clean microber towel.
Use Instrucons
Simply set the shields in place to use.
To change the orientaon of the shield:
 Remove the LONG SCREWS (E) in Step 5.
 Unclamp the feet from the panels
 Reaach to the other side and re-insert LONG SCREWS (E).
Shields can be used vercally or horizontally without issue.
Model: WEB657, 8
Thank you for choosing Seville Classics! We hope that you enjoy your new
protecve shield. Please read through this user guide for parts list, assembly
instrucons, frequently asked quesons and contact informaon.
102020
UltraShield® Acrylic Tabletop Shield

Parts List
Please make sure you have all the parts on this list.
If you’re missing parts, contact us for replacements at
[phone] or send an email to [e-mail]
1
A. Panels (1) D. Gaskets (4)
B. Clamps (2) E. Long screws (2)
C. Feet (2) F. Small screws (4)
Step 1.
Align FEET (C) side-by-side by aligning
the screw holes.
Pull apart CLAMPS (B).
Fit boom CLAMPS (B) over holes with
front side (no hole) towards logo.
Step 2.
Fit GASKETS (D) into CLAMPS (B).
Aach with SMALL SCREWS (F).
Assembly Instrucons
Required tools (not included): Phillips screwdriver
2
Step 3.
Lay ACRYLIC PANEL (A) at on table.
TIP: Do not remove panels from bags.
Open one side of bags to install feet.
Fit boom of panel into
metal lip of the CLAMP (B).
Step 4.
Slide upper CLAMP (B) onto lower
clamp. Make sure panel sits above
the metal lip.
Press together unl snug.
Step 5.
Aach CLAMPS (B) with LONG
SCREWS (E). Repeat for other side.