SewingMachinesPlus QM29304 User manual

SewingMachinesPlus.com Page 1
King Quilter Optional Rear Handlebar
Installation Instructions
09/05/18

Page 2 King Quilter Oponal Rear Handlebar Installaon Instrucons
QM29005 Boxed Oponal Rear Handlebar
Package Contents:
1 qty QM29304 Oponal Rear Handlebar Assembly with 4.3” display mounted to handlebar
2 qty QM10955 Screw, M6x16 SKB SS, bagged and wrapped on handle
1 qty QM23010 Cable, display to handlebar
1 qty QM23011 Cable, handlebar to machine
Note: These instrucons explain how to install the oponal rear handlebar. For oponal rear
handlebar funconality, please see the machine user manual.

SewingMachinesPlus.com Page 3
UCAUTION: Unplug the King Quilter from the
electrical outlet. All power to the machine
must be turned o when installing the
rear handles. Failure to do so can result
in damage to the machine and or the
handlebar.
1. Line up the two holes in the handlebar
bracket with those on the rear of the
machine. Slide the short bolts into holes unl
they stop. Hand ghten, and then use the
4mm wrench (included with the machine
accessories) to securely fasten the handles to
the back of the machine.
2. Once the two bolts are in place, plug the
large USB connector into the large USB
connecon jack located at the rear of the
machine.
3. The display will come pre-assembled to the
handlebar assembly with two hinges with
two screws each.
4. Connect the small QM23010 cable from the
top of the handlebar to the display. Connect
the large QM23011 USB cable from the
boom of the handlebar to the machine.
Installing Oponal Rear Handlebar
IMPORTANT NOTE: the display has a large
USB connecon on the boom for updang
the machine or display. This USB connector
is not used to connect the display to the
handlebar or the display to the machine.
This USB connector normally has a black
plug. This is to deter the user from using
this connecon to plug the handlebar into
the machine. The black plug is removed to
update the display or machine.

Page 4 King Quilter Oponal Rear Handlebar Installaon Instrucons
Troubleshoong
Aer the handlebar has been completely installed
and plugged in, test by turning the King Quilter on/
o switch to “on”. If nothing is displayed, check that
the handlebar cable on the back of the machine is
plugged in securely, that your machine is turned on,
and that the power cord is plugged into the machine
as well as a power source.
For optional rear handlebar functionality, please see
the machine user manual.
Oponal Rear Handlebar Connecons
QM23010 Top cable: display to handlebar cable, mini
USB 90 degree to mini USB 90 degree.
QM23011 bottom cable: handlebar to machine cable,
large USB connection, 90 degree to right angle.