Shappell Ice House 5000 User manual

To Order Parts, give Part No., Description and Qty Needed.
SHAPPELL CORP., 3562 W. Jefferson Hwy., Grand Ledge, MI 48837
Toll Free [phone]
CONSUMER WARRANTY
SHAPPELL CORPORATION warrants its products against defects in material
and workmanship for (1) YEAR from date of purchase. We will provide FREE
repair or replacement, in whole or in part, at our option, for any product, found
in our opinion to be defective. If return is required, freight must be prepaid.
This warranty does not cover Freight Damage, Ordinary Wear and Tear, Abuse,
Misuse or Altered Product.
WINDOWS ARE NOT GUARANTEED AT TEMPERATURES BELOW
–15 DEGREES FAHRENHEIT.
For warranty claim, send letter indicating product and explanation of defect plus
dated proof of purchase to the SHAPPELL Corp., 3562 W. Jefferson Hwy,
Grand Ledge, MI 48837.
5-26-10
REPLACEMENT PARTS
MODEL IH5000
Part# Description
5000.1 Fabric Cover
5000.2 Frame Rod
5000.3 Frame Hub
5000.4 Eyebolt & Strap
5000.5 Removable Window/Shade
IA2 Ice Anchor
WARNING: Keep all Heat & Flame Sources away from the Shelter’s Fabric
Cover. The Fabric Cover is Fire Retardant, it is not Fire Proof. The use of any
heat source can be extremely dangerous, both for Fire Hazard and Carbon
Monoxide Emissions. The Shappell Corporation does not endorse the use of any
Heater. It is the user’s responsibility to follow the Instructions and Warnings
provided by the Heater Manufacturer for the safe use of a particular Heater.
CARBON MONOXIDE POISONING HAZARD: This shelter must be
ventilated if using an oxygen consuming heat source. DO NOT PACK SNOW
AROUND SHELTER or in any way prevent fresh air from entering shelter.
Failure to Ventilate Shelter could create a Serious Health Hazard or Death.
Window can not be made to withstand temperatures below –15oF. (see warranty)
MAINTENANCE: After each use, set up shelter until fabric is completely dry.
Never leave shelter folded closed with a wet cover.
NOTICE: It is normal for fabric to have some pinholes. This does not affect
water repellency.
READ SETUP & TAKEDOWN INSTRUCTIONS BEFORE USING SHELTER
IMPORTANT SAFETY INFORMATION
CO
TM

Set Up Take Down
1) Remove Tent from
Bag and set Hub End
on Ice. (Fig. 1)
2) Unfold Tent and
screw in Ice Anchor
at one corner eyelet.
(Fig. 2)
3) Jerk up hard on Top Hub so it pops up. (Fig. 3)
Fig. 2
Fig. 3
4) Pull out Side Hub while pushing
against Top Center. (Fig. 4)
5) Pull out remaining Side
Hubs. (Fig. 5) Fig. 4
Push
Pull
6) Install remaining Ice Anchors as
needed. (Fig. 6)
1) Remove Ice Anchors, leaving
one. Push in on Side Hub so it
pops in. (Fig. 7)
2) Push remaining Side
Hubs in. (Fig. 8)
3) Push Top Hub down. (Fig. 9)
Fig. 10
4) Remove last Ice Anchor and Fold all corners up. (Fig. 10) & (Fig. 11)
5) Put tent into Bag with Hubs at the Bottom of Bag. (Fig. 12)
Fig. 7
Push
Fig. 9
Push
Fig. 5
Push
Pull
Fig. 8
Push
Fig. 12
Shoulder Carry Straps
Fig. 11
Fig. 1
Fig. 6