Sharedband Power Router Pro User manual

Verify It All Works
Once everything is connected, log in to any one of the Sharedband Routers. Click on
Diagnoscs then Sharedband Service.
You’re able to view the status of all connected Routers by clicking on the
“Diagnoscs” buon.
More Informaon
Help and Support is available online at: hp://support.sharedband.com
Sharedband Power Router Pro QIG 4www.sharedband.com
Sharedband Power Router Pro
Quick Install Guide

Hardware Setup
Remove the Router(s) from their packaging and placing them in a suitable locaon.
The recommended setup is to connect the Routers together via an unmanaged
switch. However if you only
have 1 Power Router Pro you
can plug this directly into
your network or rewall.
Aer connecng the
Sharedband Routers togeth-
er the next step is to connect
them to the phone line. This is done with the thin black cables found in the box for
each Router. Please ensure you are only using one microlter per line or connecng
directly to the master socket.
Plug the power lead into the back of the Router and into the nearest power outlet.
Soware Setup
Now the Routers are powered on, its me to congure the ADSL details. You should
have received the details when your ISP installed your lines or when you signed. If
your unable to locate the details, call your ISP and request the ADSL log in details.
Using a PC connected directly into the Sharedband Router, or the Switch if you used
one, open a web browser and go to this address.
hp://192.168.3.1/
You will be presented with a log in screen. The defaults are:
Username: admin
Password: Bonding123
(You should change the password once setup is complete)
Sharedband Power Router Pro QIG 2www.sharedband.com
Once you have logged in you will be presented with the Main Menu. Click on
Sengs then click WAN Connecon Sengs (ADSL 0)
On this page enter your ADSL log
in details. You will need to select
PPPoA from the drop down box
(unless the paper work from your
ISP dictates otherwise). In the
following two boxes enter your
ADSL Username and Password,
and press Save.
Click on Sengs then click WAN
Connecon Sengs (ADSL 1).
Enter the ADSL details for the sec-
ond connecon and press Save
and Reboot.
Router should now be connected to the
Internet. This will be indicated by the
LEDs on the front of the router. For
more informaon click on Diagnoscs
then ADSL 0 Link Status.
If you have mulple routers, repeat the
above steps for the other Routers. Each
router has dierent IP address. This
corresponds with the number wrien
on the base of the Router. For example
router two will be hp://192.168.3.2,
Router 3 will be hp://192.168.3.3, etc.
www.sharedband.com 3Sharedband Power Router Pro QIG