Sharedband Power Router 1 User manual

June 2017 http://www.sharedband.com 1 of 3
Sharedband Bonded Broadband
Sharedband Power Router 1
Configuration Guide
Introduction
This document is to instruct you how to configure the Sharedband software on Sharedband Power Router 1.
Note: This guide assumes that the Router is not pre-configured.
Preparation
Make sure you have the Sharedband user details for the Community you wish to setup.
The Procedure
Do not skip any of the steps, as the configuration is not activated until ‘Save and reboot’ is selected
at the end of the last step.
Step 1: Log onto the Web interface of the router (default address http://192.168.3.17). The default login is
'admin' and password 'Bonding123'.
Step 2: Click 'Settings' > 'Sharedband Service Configuration'.

June 2017 http://www.sharedband.com 2 of 3
Step 3: You should now be presented with a screen like this:
The details required for this screen are those generated when creating the user on the Sharedband NOC.
The only value which differs is the 'Node ID' (1 –8 depending on the Router number) for your WAN Ethernet
connection.
Once completed click 'Save’, and proceed to the next step.
Step 4: Verify the WAN configuration details for the connection that will be in use. Click 'Settings', then work
through both 'WAN connection setup (Ethernet)' screen. The screen will look like the following:
For many setups the default addressing mode of ‘Dynamic IP (DHCP)’ will be suitable, but the device allows
configuration of ‘Static IP’ and ‘PPPoE’ options if needed.
Once completed click 'Save’, and proceed to the next step.

June 2017 http://www.sharedband.com 3 of 3
Step 5: You will need to change the LAN IP of the router, which you will find under 'Settings'>'LAN settings'.
This is normally set to 192.168.3.X(Xbeing the node number). The recommendation is to increment the last
digit for each Sharedband router, for example the second unit would have an address of 192.168.3.2.
This is also where you can change the VRRP Address and Subnet for routed mode, this must be the same
on all routers (for more information on routed mode, please contact support).
For the change to take effect, the router will need to be rebooted by clicking the 'Save and reboot' button.