Shark Rocket DuoClean User manual

Please be sure to read the enclosed Shark® Owner’s Guide prior to using your vacuum.
ASSE MBLY
AHandheld Vacuum
BMotorized Floor Nozzle
CWand
DDuster Crevice Tool
WHAT’S INSIDE VERSATILE FLOOR-TO-CEILING CLEANING
UV480_QSG_E_MP_Mv3
A DB C
QUICK START GUIDE
DuoClean® with Self-Cleaning Brushroll Corded Stick Vac
Rocket®
(Click)
(Click)
1 2
Settings
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in
carpets) please use Setting II, Carpet.
Slide switch to
the bottom to
turn o power. To
begin vacuuming,
slide switch to
the appropriate
setting.
Bare Floor/Small
Area Rugs
The brushrolls
spin slowly to
clean bare floors
and delicate
arearugs.
Carpet
The brushrolls
spin faster to pick
up debris below
the surface ofyour
carpets.
OFF SETTING I SETTING II
NOTE: All accessories are compatible with both the wand and the
handheld vacuum. Use Setting I for all above-floor accessories.
Stand the vacuum upright.
Step on the foot pedal on
the floor nozzle and pull
the wand up to disconnect
it. Great for cleaning
baseboards, ceiling fans,
window sills, etc.
Press the WAND RELEASE
button and lift the handheld
vacuum o the wand. Great
for cleaning stairs and
furniture.
Above-Floor
with Wand
Above-Floor
with Handheld
Upright Mode
To clean floors, place foot on floor
nozzle and tilt handheld vacuum back.
NOTE: Select Carpet for stuck-on dust and debris.

STORAGE
Hang the handheld
vacuum on the hook
on the bottom of the
wand, and wrap the
power cord around
the cord hooks.
Onboard Hook
For questions or to register your product, visit us online at sharkclean.com
@sharkcleaning
©2019 SharkNinja Operating LLC.
NOTE: If you see any hair wrapped around the brushroll, continue
cleaning, using Setting II, Carpet, on bare floors. This will allow the
self-cleaning brushroll to remove the hair wrap and send it to the
dust cup.
MAINTENANCE
DUST CUP
Brushroll Maintenance
With the garage lid removed, carefully clear away any
debris that may be impeding the brushroll.
Checking the Nozzle for Blockages
Tilt neck of nozzle back to straighten the airway, then
remove any blockages.
Brushroll/Soft Roller Access
1. To open the brushroll garage, slide both release buttons
on the floor nozzle away from you, toward the back of the
nozzle, then lift o the lid.
2. To close the brushroll garage, insert the 3 tabs on top of
lid into the 3 slots in the nozzle, then push down on both
sides of lid until it clicks securely into place. If Brushroll
Indicator Light is green and headlights are flashing, check
again that both sides of lid are locked in place.
Cleaning the Soft Roller
Open the brushroll garage. Lift out the Soft Roller by
pulling the tab on the right side. Clear away any debris,
then slide the Soft Roller back into place.
Empty dust cup every time debris reaches the MAX fill line.
Empty
Dust Cup
Release
With the dust cup
attached to the
handheld vacuum, hold
the dust cup over a trash
bin and press the Empty
button on the front of
the dust cup.
To remove the dust cup
from the handheld vacuum,
squeeze the two Dust Cup
Release buttons at the same
time and pull out the dust
cup. Holding the dust cup
over a trash bin, press the
Empty button on the front
of the dust cup.
NOTE: Wrap the power cord around the top hook first, leaving a
little slack.