Brushroll garage for easy access to your brushrolls.
Open the brushroll lid by sliding both release buttons away from you, toward the back of
the nozzle, then lifting o the lid.
To close the brushroll lid, insert the 3 tabs on top of lid
into the 3 slots in the nozzle, then push down on both sides of lid until it clicks securely
into place.
If headlights flash when the power is turned on, the brushroll lid is not completely
secured, and the brushrolls will not engage and the vacuum will not operate.
HAVING
TROUBLE?
ISSUE
Vacuum is not picking
up debris. No suction
or light suction.
Solution
Empty dust cup, clean
filters, check all openings
for blockages.
ISSUE
Vacuum lifts area rugs.
Solution
Turn o the unit to disengage
the brushroll and restart with
the Power button.
ISSUE
Brushroll and/or Soft Roller
does not spin. The Brushroll
Indicator Light on the floor
nozzle turns red.
Solution
Turn o the unit and move
away from any obstruction,
then turn on power and tilt
handle back. If the light
remains red, turn o and
unplug the vacuum. Disconnect
the nozzle and remove any
blockages. Make sure the
brushroll lid is firmly locked
into position on both sides.
Plug in the vacuum, turn on
power, and tilt handle back.
If Brushroll Indicator Light
isn’t green and headlights
are flashing, check again
that both sides of the lid
are locked into place. If the
light is still red, please
contact customer service at
1- 8 00-798-7398 .
1
UPRIGHT MODE
Use for carpet and
hard-floor cleaning
2
LIFT-AWAY®
MODE
Use for portable cleaning
on stairs or above-floor areas
3
CANISTER MODE
Convert your upright to
a convenient canister
(caddy sold separately)
3 WAYS TO CLEAN MAINTENANCEDUOCLEAN™TECHNOLOGY
Hard Floor
Gentle on bare floors and delicate area rugs.
Thick Carpet/Area Rug
Optimized brushroll speed and suction for
thick carpets and delicate area rugs.
Carpet/Low Pile
Optimized brushroll speed
and suction for carpets.
Empty dust cup after each use
Empty
Release
TIP:
Wash filters to keep the
suction strong.
Rinse filters and allow to air-dry
completely. Tap loose dirt
from foam filters as needed
between washes.
See enclosed Owner’s Guide
for complete details on
removing and cleaning filters.
Lift-Away
Release
Wand
Release
Handle
Release
Floor Type
Power Button
Attach any of the
specialized cleaning
accesso ries to the
handle or wand.
Place foot on floor nozzle andtilt handle back.
Choose appropriate floor setting and press power button.
Press Lift-Away Release button to lift
pod o floor nozzle. You are now ready to
clean those hard-to-reach places.
From Lift-Away mode, place pod onto caddy.
The brushroll will
spin slowly to
help with debris
pickup.
The brushroll
will spin faster
to help pick up
debris below
the surface.
When you are
done cleaning
with your caddy,
press the Lift-Away
Release button to
remove the pod.
ON FLOORS
Direct engagement with the Soft Roller removes
large particles, small particles, and stuck-on dust.
ON CARPETS*
The Soft Roller pulls in large particles, while the
deep-cleaning bristle brush removes embedded fine dirt.
*For deep cleaning per ASTM F 608 (embedded dirt in carpet) please use in Carpet/Low Pile mode.
Brushroll Maintenance.
Remove any string, hair, or debris
that may be wrapped around the
brushroll by running scissors along
the guide on the brushroll.
Soft Roller Maintenance.
Lift out Soft Roller by the tab on the right
side. Clean o any string, carpet fibers, or
hair that may be wrapped around the Soft
Roller. Remove debris from the roller housing.
Reinsert the Soft Roller by sliding it into the
front of the nozzle until it clicks into place.
