Shark UV410 User manual

Owner’s Guide
www.sharkclean.com
UV410
UV410_26_IB_ENG_120229_5.indd 1 12-02-29 1:30 PM

TOLL FREE: 1-800-798-7398
This manual covers model numbers:
UV410 26
TECHNICAL SPECIFICATIONS
Voltage: 120V.
Watts: 1200W
Amps: 10A
Hertz: 60Hz
UV410_26_IB_ENG_120229_5.indd 2 12-02-29 1:30 PM

1
www.sharkclean.com
Contents
Important Safety Instructions 2
Getting Started 4
Using the Vacuum 6
Cleaning with the Vacuum Accessories 7
Emptying the Dust Cup Assembly 8
Proper Care of Your Vacuum 9
Troubleshooting 10
Checking for Blockages 11
Maintenance 12
Warranty and Registration 13
Thank you for
purchasing
the Shark®
Navigator™
Upright Vacuum.
UV410_26_IB_ENG_120229_5.indd 1 12-02-29 1:30 PM

2
TOLL FREE: 1-800-798-7398
WARNING:
TO REDUCE THE RISK OF ELECTRIC
SHOCK OR INJURY DO NOT USE
OUTDOORS OR ON WET SURFACES.
WHEN USING YOUR SHARK®NAVIGATOR™
UPRIGHT VACUUM, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS BEFORE USING
YOUR SHARK®NAVIGATOR™UPRIGHT
VACUUM.
POLARIZED PLUG:
This appliance has a polarized plug (one blade
is wider than the other). As a safety feature, this
plug will fit into a polarized outlet only one way.
Do not force into the outlet or try to
modify the plug to fit.
IMPORTANT SAFETY INSTRUCTIONS
For Household Use Only
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR INJURY:
GENERAL ELECTRICAL SAFETY:
1. Unplug from electrical outlet when not in use
and before servicing.
2. DO NOT use vacuum with a damaged cord or
plug.
3. DO NOT pull or carry vacuum by the cord.
4. DO NOT unplug by pulling on cord; to unplug,
grasp the plug, not the cord.
5. DO NOT handle plug or vacuum cleaner with
wet hands.
6. DO NOT run the vacuum over the power cord.
7. DO NOT close a door on the cord.
8. DO NOT pull cord around sharp corners.
9. DO NOT leave appliance when plugged in.
10. Keep power cord away from heated surfaces.
11. Turn off all controls before plugging or
unplugging vacuum cleaner.
12. Always turn off this appliance before connecting
or disconnecting the motorized nozzle.
HOSE ATTACHMENTS:
13. DO NOT use if air flow is restricted; if the air
paths, the hose or the extension tube become
blocked, turn the vacuum cleaner off. Remove
all obstructions before you turn on the unit
again.
14. Keep the end of the hose, wands and other
openings away from face and body.
15. Keep rotating brush and suction openings away
from hair, face, fingers, uncovered feet or loose
clothing.
16. Only use manufacturer’s recommended
attachments.
UV410_26_IB_ENG_120229_5.indd 2 12-02-29 1:30 PM

3
www.sharkclean.com
GENERAL USE:
17. Use only as described in this manual.
18. DO NOT put any objects into openings.
19. Keep your work area well lit.
20. Keep the vacuum moving over the carpet
surface at all times to avoid damaging the
carpet fibers.
21. DO NOT place vacuum on unstable surfaces
such as chairs or tables.
22. DO NOT allow young children to operate the
vacuum or use as a toy.
23. DO NOT use vacuum cleaner if it has been
dropped, damaged, left outdoors or submerged
in water. Return to EURO-PRO Operating LLC
for examination, repair or adjustment.
CYCLONIC CHAMBER/DUST CUP/FILTERS:
24. Before turning on the vacuum:
 • Makesurethatdustcup,cyclonicchamber
and all filters are in place after routine
maintenance.
 •Makesurethatallcomponentsandfiltersare
thoroughly dry after routine cleaning.
 • Onlyusefiltersandaccessoriesprovidedby
EURO-PRO Operating LLC [Failure to do so
will void the warranty].
GENERAL CLEANING:
25. DO NOT run the vacuum over large-sized
objects.
26. DO NOT pick up hard or sharp objects such as
glass, nails, screws or coins that could damage
the vacuum cleaner.
27. DO NOT pick up smoking or burning objects
such as hot coals, cigarette butts or matches.
28. DO NOT pick up flammable or combustible
materials such as lighter fluid, gasoline,
kerosene or use in areas where they may be
present.
29. DO NOT pick up toxic solutions such as
chlorine bleach, ammonia or drain cleaner.
30. DO NOT use in an enclosed space where
vapors are present from paint, paint thinner,
moth-proofing substances, flammable dust or
other explosive or toxic materials.
31. DO NOT vacuum up any liquids.
32. DO NOT immerse vacuum cleaner in water or
other liquids.
33. DO NOT use outdoors or on wet surfaces; use
only on dry surfaces.
34. Use extra care when cleaning on stairs.
SAVE THESE
INSTRUCTIONS
UV410_26_IB_ENG_120229_5.indd 3 12-02-29 1:30 PM

4
TOLL FREE: 1-800-798-7398
FIRST THING’S FIRST, YOU
NEED TO KNOW WHAT’S IN THE
BOX YOU JUST OPENED:
AVacuum Body
BFloor Power Nozzle
CHandle Assembly
DSuper Stretch Hose
ECleaning Wand
FPet Hair Power Brush
GCleaning Attachments
H24” Crevice Tool
I Extended Reach Kit
* Note: Optional tools are available for sale
for any UV410 model: 1-800-798-7398.
Getting Started
Your Shark®Navigator™
Upright is easy to assemble:
1Lay your vacuum body on a
level surface.
2Slide the electrical connection
from the power nozzle into the
main body to click into place.
3Connect the hose from the main
body to the power nozzle; push
with a slight turning motion to
create a snug fit.
4Slide the handle assembly
into the upright unit aligning
the hose hook on the handle
assembly with the power cord
hooks on the back of the unit.
5Secure the handle assembly in
place with included nut/bolt
(shipped attached to handle
assembly).
6Place the vacuum in the upright
position.
7Store the Crevice Tool, Dusting
Brush and Cleaning Wand on
the unit.
A C E
4
5
3
7
2
G
H
B
F
D
I
UV410_26_IB_ENG_120229_5.indd 4 12-02-29 1:30 PM

5
www.sharkclean.com
IMPORTANT:
For suction to reach the Floor
Power Nozzle, the Cleaning
Wand and Super Stretch Hose
must be attached securely on
the vacuum body.
10 To carry the vacuum:
With the unit in the standing
position, lift by the Dust Cup
Handle.
CAUTION: When lifting or
carrying, DO NOT press Dust
Cup Assembly release button.
8Attach the Super Stretch Hose:
a) Snap hose into swivel
connector
b) Route under anti-tip hook
c) Route over upper hose
holder
d) Press securely onto cleaning
wand
IMPORTANT:
To prevent vacuum from
tipping, secure hose under the
anti-tip hose hook.
9 To store the vacuum:
When storing your vacuum,
wind the cord around the two
cord holders and secure with
cord clip:
 •QuickCordreleaseatthe
top of the unit – place in the
upright position.
 •Cordholdernearthebase–
turn it until it is pointing down.
 Toreleasethecord,turntheQuick
Cord release to the left or right.
Store the Extended Reach Kit,
the Pet Hair Power Brush and
the 24" Crevice Tool with the
vacuum when not in use.
c
8 9
d
b
a
UV410_26_IB_ENG_120229_5.indd 5 12-02-29 1:30 PM

6
TOLL FREE: 1-800-798-7398
Using the Vacuum
IMPORTANT: To protect your
carpets, the brushroll will only
turn on when you have pulled
the handle back towards you and
released the Floor Power Nozzle.
Your Shark®Navigator™Upright
Vacuum can be used to clean bare
floors or carpets – with the click of
a switch.
Stand the vacuum into the upright
position.
Plug in the vacuum.
1Start with the Power Switch in
the “O"- Off position.
2Place your foot on the Floor
Power Nozzle and pull handle
towards you.
3Set the Power Switch to desired
cleaning setting.
4When cleaning carpets:
Ensure you have pulled the
handle towards you and select
the “II" - Brushroll On position
to agitate the carpet fibers for
deeper cleaning performance.
When cleaning bare floors:
Select the "I"- On position for
suction only cleaning to avoid
scattering dirt while cleaning.
5Due to the huge suction
power of this vacuum, it
may become necessary to
adjust the suction release
on the hose. If the vacuum
is difficult to push or pull or
if it is lifting up area rugs,
adjust the suction release by
opening or closing the valve
at the top end of the hose.
IMPORTANT:
Your Brushroll Indicator Light
will illuminate solid green when
the brushroll is on, or solid red if
there is a blockage. This feature
is designed to protect your
Lifetime Belt that powers your
brushroll. See Checking for
Blockages on page 11.
NOTE: The height of your power
nozzle has been optimized
for easy pushing and superior
cleaning on all floor types, so
there is no need to make any
height adjustments as you
transition to different floor &
carpet types.
OFF
Bare Floors /
Tools
Carpets
Power Switch Settings Suction Release
Release suction for
easier push and pull
on high pile carpets
and area rugs.
UV410_26_IB_ENG_120229_5.indd 6 12-02-29 1:30 PM

7
www.sharkclean.com
Cleaning with the Vacuum Accessories
Before cleaning with your
accessories:
Stand vacuum into upright position.
Secure Super
Stretch Hose in
the anti-tip hose
hook to prevent
tipping.
Select the “I" - On position for
suction only cleaning.
DO NOT pull vacuum cleaner
around by the hose.
DO NOT overextend the hose.
Vacuum Accessories
Your vacuum comes with a Super
Stretch Hose and Cleaning Wand.
Use one or the other to attach your
cleaning accessories.
1Using the Super Stretch Hose:
Stand the vacuum into upright
position.
Remove the hose from the
Cleaning Wand.
Push the selected tool into the
hose connector.
1
3
456
2
3
456
2Using the Cleaning Wand:
Stand the vacuum into upright
position.
Remove the Cleaning Wand
(with hose attached) from the
unit.
Push the selected tool into the
end of the Cleaning Wand.
3Pet Hair Power Brush
4Dusting Brush
5Crevice Tool
624” Crevice Tool
Extended Reach Cleaning Kit
Includes an extra Cleaning Wand and
extra Super Stretch Hose.
Increases your cleaning
reach to over 27 feet!
To order additional parts and accessories,
go to www.sharkclean.com or call
1-800-798-7398.
Extended Reach
Cleaning Kit
UV410_26_IB_ENG_120229_5.indd 7 12-02-29 1:30 PM

8
TOLL FREE: 1-800-798-7398
For best results empty the Dust Cup
after each use; empty several times
during prolonged usage. or when it
reaches the MAX fill line.
NEVER OVER-FILL THE DUST
CUP.
Stand vacuum into upright position.
Turn vacuum off.
To empty the Dust Cup:
1Grip carry handle and press
the Dust Cup release button to
remove.
2Option A:ForQuickEmpty:
Insert Dust Cup deep inside
trash receptacle to contain dust
and debris.
Press the bottom Dust Cup
release button; tap container
gently to dislodge and release
dust and debris.
Snap door in place.
Important: If the Dust Cup
Door does not swing open after
pressing the release button,
push the door open using the
bottom door tabs.
CAUTION:
Unplug the vacuum;
failure to do so might
result in electric
shock.
3Option B: For Allergy Sufferers:
Wrap a trash bag around the
Dust Cup leaving space at the
bottom for the door to swing
open.
Locate the Dust Cup Door
release button within the trash
bag and press to release as you
shake the dust cup to empty
dust and debris.
Snap the bottom door in place.
Note: Option B can also be
performed outside of the home
to further minimize releasing
dust back into the air. Carry just
the Dust Cup and trash bag
outside.
Note: Some dust and debris
may remain in the top of your
dust cup on or near the metal
screen. It is not necessary to
completely remove this material
before continuing to vacuum;
Shark®advanced cyclonic action
will sweep the metal screen
clean once you begin to refill
your dust cup.
1 2 3
Emptying the Dust Cup Assembly
UV410_26_IB_ENG_120229_5.indd 8 12-02-29 1:30 PM