Shark Vertex IZ1441H User manual

QUICK
START
GUIDE
Please make sure to read the enclosed Shark®Owner’s Guide prior to using your vacuum.
IZ441H_QSG_MP_Mv2
EMPTYING THE DUST CUP
MultiFLEX
Lock Release
Wand Release
Button
Dust Cup
Release Button
IZ1441H
For questions, visit us online
at sharkclean.com/support
©2020 SharkNinja Operating LLC.
DUOCLEAN, MULTIFLEX, and SHARK are registered trademarks of SharkNinja Operating LLC.
VERTEX is a trademark of SharkNinja Operating LLC.
STORE ANYWHEREREACH ANYWHERE
Press the MultiFLEX Lock Release button
and fold the handheld vacuum forward.
To vacuum, lift up the handheld vacuum,
until the wand locks in place.
Press the MultiFLEX® Lock Release
button to lower the angle of the
wand to increase your reach.
1. To empty dust cup,
first disconnect the
handheld vacuum
from the wand by
pressing the Wand
Release button and
pulling up on the
handheld vacuum.
2. Position dust cup
over a trash bin and
slide the lid release
button forward.
POWERFINS
DuoClean® PowerFins Cordless Vacuum
with Self-Cleaning Brushroll

AHandheld Vacuum
BDuoClean® PowerFins Floor Nozzle
CMultiFLEX® Wand
DCrevice Tool
EDusting Brush
FAnti-Allergen Brush
GCharger
HHEPA Post-Motor Filter (Pre-Installed)
WHAT’S INSIDE: POWER SETTINGS
LI-ION BATTERY
ASSEM B LY
OFF BARE FLOOR
SETTING CARPET SETTING BOOST MODE
Slide switch to the
top to turn o power.
To begin vacuuming
in Standard Mode,
slide switch to the
appropriate setting.
Bare Floor/Area Rugs
Slide switch to the
middle. The brushroll
spins slowly to clean
bare floors and small
arearugs.
Carpet
Slide switch to the
bottom. The brushroll
spins faster to pick up
debris below the surface
ofyour carpets.
For an added boost in
power, pull the Trigger
on the handheld
vacuum. Release it
to return to standard
power.
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please select the Carpet setting and pull the
trigger to go into Boost mode.
NOTE: Select Carpet setting for stuck-on dirt and debris.
In Use
Full
Charge
Mid
Charge
Low
Charge
Nearly
Empty
No
Charge
Charging
Low
Charge
Mid
Charge
Nearly
Full
Full
Charge
NOTE: Full charge takes approximately 3 hours.
CHARGING
Battery Indicator Lights
NOTE: The battery comes
partially charged. Charge fully
before first use.
E F
G H
D
For additional parts and accessories, visit sharkclean.com
A
B
C
2
(Click)
1
(Click)
To charge, remove the
handheld vacuum from the
wand by pressing the Wand
Release button and pulling
up. Plug the charger into
the charging port.
To put the vacuum in storage
mode, press the MultiFLEX
Lock Release button while
folding the handheld vacuum
forward until the wand clicks
and locks. Plug the charger
into the charging port on
the battery.
Battery Runtime
MODE MINUTES
Hand Vac 50
Bare Floor/
Standard Mode 34
Carpet Mode/
Standard Mode 23
Boost Mode
(Hand Vac) 10