Sharp AN-GR500H User manual

1
Accessories
2
Installing the glass and the glass protector
TINSEA270AWZZ
08G R MW 1
MODEL
AN-GR500H
HOME CINEMA RACK SYSTEM
This quick Start Guide will help you to correctly install and operate your system.
1
If you require any advice or assistance regarding
your Sharp product, please visit our web-site
www.sharp.co.uk/customersupport.aspx
Customers without internet access may
telephone [phone] during office hours (or
[phone] if telephoning from Ireland).
Top glass x 1 Bottom glass x 1
Remote control x 1 Adjustable nylon band x 3
Glass protector x 4AC power lead x 1
FM aerial x 1
"AA" size battery
(UM/SUM-3, R6, HP-7 or similar)
x 2
1. Fix the glass protector to the top glass at each corner.
Make sure the "TEMPERED" sticker on top of the glass
is facing up.
TEMPERED
TEMPERED
TOP VIEW
Step 1 Step 2
BOTTOM VIEW
Step 1 Step 2
“TEMPERED” sticker
2. Place the top glass on top of the frame.
Make sure all the glass protector guide is fitting to the frame hole.
TEMPERED
TEMPERED
Glass protector
Subwoofer box
Top glass
Frame hole for
the glass protector
to fit in.
Bottom
glass
“TEMPERED” sticker
“TEMPERED”
sticker
3. Place the bottom glass on top of the subwoofer box.
Make sure the “TEMPERED” sticker on top of the glass is facing
up.
Notes:
It is advisable for the top glass to be carried by 2 persons.
Top glass with sticker on its surface, must face upwards.
Metal frame must not be removed to ensure safety.
The maximum load for the top glass on the unit is 100 kg.
The glasses are made of reinforced glass, but dropping pointed
objects on them or strongly hitting the surface may cause them to
break.
Top and bottom glass are not fastened to the unit. Always take
care when transporting it, otherwise these parts may fall off and
there is a risk of damage and injury.

XL-UR230/250/2110HE QG 1/17/07, 4:44 PM2
3
Remote control battery installation
5
To turn the power on
4
Connecting the AC power lead
1Open the battery cover.
2Insert the batteries as shown.
3Close the cover.
Use 2 “AA” size batteries (UM/SUM-3, R6, HP-7 or similar).
Notes:
Press the ON/STAND-BY button.
If the power does not turn on, check whether the power lead is plugged in properly.
To set the unit to stand-by mode:
Press the ON/STAND-BY button again.
Note:
After the unit enters the power stand-by mode, wait a few seconds to turn on again
Wall socket
(AC 220 V- 240 V, 50 Hz)
After checking all the connections have been made correctly,
connect the AC power lead to the AC power input socket, then
to the wall socket.
Never use a power lead other than the one supplied. Other-
wise, a malfunction or an accident may occur.
Unplug the AC power lead from the wall socket if the unit will
not be in use for a prolonged period of time.