Shear Magic PROFESSIONAL Tuffy T5000 User manual

1
You must charge
your batteries
BEFORE USE
PO BOX 260 BOTANY NSW 1455
Email: [email protected]
Website: www.shearmagic.net.au
ABN 31 128 341 980
Ph: 02 4624 8950
Instruction Manual
Tuffy 5000
Cord/Cordless Clipper
PLEASE REFER TO THIS INSTRUCTION MANUAL BEFORE USE

2
Component Names
Specifications
Model T5000
Dimension 180×49×46mm (L×W×H)
Weight (without blade) 268g
Watt 12W
Battery Type Li-ion Battery 3.7V, 3200mAh
Adaptor DC Switching power Supply 5V/2.5A
Working time about 150 min
Charging time: about 120 min
Strokes Per minute 5,000
Coating of clipper housing ABS
Material of blade Tool Steel
Accessories Instruction manual, power supply, cleaning brush,
and lubricant oil
a. Clipper Body
b. Blade Set
c. Switch On/Off
d. Light Indication
e. Charging Socket
1. Power Supply
2. Charging station
3. Oil
4. Cleaning Brush

3
Light Indication
Power Indicator Warning Sign
Charging Fully
Charged
Motor
Running
Low
battery Overloading Charging Fault
Blue Light
Flashing
Blue LED
Light Up
Blue LED
Light Up
Red Light
Flashing
Slowly
Red Light
Flashing
Urgently
Red and Blue
LEDFlashing
Alternately
After the battery is placed in the adaptor plug, it takes 3 seconds to detect before it
can start charging.
Red Light Flashing Slowly
Please charge the clipper if the red LED light is flashing slowly.
Red Light Flashing Urgently
Please remove the attached power and turn off the clipper when the motor stop
and the red light flashes urgently.
Clean the blades and lubricate them with oil. Then, turn the clipper on again.
If the clipper still malfunctions, please send the clipper to a qualified agent for
maintenance.
Red and Blue LED Flashing Alternately While Charging
Please remove the power supply or adapter that is attached to the clipper.
Please clean the charging port on the clipper body and the slot on the charging
base. Recharge the clipper again and check if the clipper starts to be charged
successfully. If the error sign constantly shows again, please send the device to the
qualified retailer or maintenance service.

4
Important Safeguards
When using the electrical appliance, basic precaution should always be followed.
DANGER - to reduce the risk of electric shock:
1. Do not reach for an appliance that has fallen into water. Unplug immediately.
2. Do not use while bathing the animal.
3. Switch off/unplug the appliance when not in use and allow it to cool down before
storing it in a safe place.
4. Do not lay metal objects across positive (+) and negative (-) battery terminals,
charger terminals or clipper terminals
5. WARNING: Keep unit dry at all times
6. Always return unit to the charging stand after using
7. Do not disassemble clipper
8. Make sure the local voltage is the same as adaptor input before charging.
9. Make sure clipper is switched off while charging.
10. Please do not use device near water
WARNING - to reduce the risk of burns, fire, electric shock or injury to persons:
1. An appliance should never be left unattended when plugged in.
2. Keep away from heated surfaces.
3. Keep the air openings free of hair, fur or the like.
4. Never drop or insert any object into any openings.
5. Do not wrap cord around unit when storing. Continuous stress on
the charger cord can damage charging performance
6. Avoid contact with moving blades
7. Do not attempt to charge any battery pack or device other than
intended Shear Magic battery
8. During use, do not place or leave the appliance where it is expected to:
a. subject to damage by animal or
b. exposed to weather
9. Do not discard exhausted battery packs into fire
10. This appliance is for clipping and trimming of animal only
11. Use only Shear Magic Professional genuine parts that are supplied by
Botany Bay Imports
12. Store items at room temperature
13. Charge the Lio-Ion batteries prior to first use
14. Ensure that your clipper is serviced only by a qualified repair person
15. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.

5
16. Children should be supervised to ensure that they do not play with the
appliance.
17. The appliance is only to be used with the power supply unit provided.
It must only be supplied at safely extra lower voltage corresponding to the
markings on the appliance.
18. WARNING: Cutting blades may become hot after prolonged use.
19. WARNING: For the purpose of recharging the battery, only use the authorise
batteries with this appliance.
20. WARNING: Keep the appliance dry
21. This appliance contains batteries that are only replaceable by skilled persons
22. WARNING: For the purpose of recharging the battery, only use the detachable
supply unit provided with this appliance.
Operation
BEFORE USE
1. Plug the power supply into the charging socket of the clipper
2. Please charge the clipper for about 3 to 4 hours prior to
using. For new appliance, it should be charged 3-5 times to
reach the maximum efficiency of the battery
3. Battery should be charged 3 to 4 hours after it was unused
for 3 months or more.
4. Plug the power into socket and the light indication lights up.
AFTER USE
1. Be sure the clipper is OFF.
2. Make sure to clean out the hair and lubricate
the blade after using.
3. Use cleaning brush to clean the blade set.
4. The blade set can be removed by grasping the cutting
end of the blade assembly and push the blade away
from the clipper (Fig 1)
5. Use oil (2~3 drops) to lubricate the blade teeth.
(Only use clipper blade oil) (Fig 2)
6. To re-assemble, reverse the above procedure,
pushing the blade until it firmly clicks back into its position.
BATTERY & BLADE
If you haven’t used your clipper in over 3 months. It is recommended that you
discharge then fully charge the battery.
For best cutting performance it is important to brush out any hair using a cleaning
brush and to oil the blades before, during and after use.
Fig 1
Fig 2

6
Basic Trouble Shooting
MALFUNCTION CAUSE RECTIFICATION
Blade set is
unable to fit
onto the clipper
Slot of blade and
moving blade do
not fit well
Push the blade lightly to the middle
location
Clipper does not
turn on
Battery flat Charge battery as per instructions
Smell of burning
from the motor
Motor may need replacing
Adaptor voltage Change the adaptor
Motor Motor may need to be replaced
Clipperhead full
of hair
Clean and oil clipperhead
Blade sharpness Change the blade set
SHARPENING BLADES
After extended use, the blades will begin to lose factory cutting edge and will need
resharpening. To avoid the loss of clipping time, you may wish to keep a spare set of
blades on hand. Contact Botany Bay Imports for blade re-sharpening 02 4624 8950.
CLIPPER SERVICE
Your clippers should be serviced on a regular basis for an authorized service centre
please contact: Botany Bay Imports 02 4624 8950 or visit botanybayimports.com.au.
Battery
• Assembled with the Li-ion battery.
• If not using for a long period, recharge and use the clipper once three months to
expand the battery’s lifespan
• WARNING: Only use genuine Shear Magic batteries suitable for this model.
• To ensure the lithium-ion battery reaches its full potential, the battery should be
drained after the first use. It will take more than 120 minutes for the battery to be
fully charged when fully discharged.
• When the battery is fully charged, the clipper can be used for up to 150 minutes
CHANGING THE BATTERY
• Send the unit to an authorised service agent.
Do not dispose of batteries and clippers with household items.
Do not throw batteries into fire or water. Defective or exhausted
batteries and clipper must be collected and recycled or disposed
of in environmentally compatible ways according to national,
regional and local news, regulations and directives.

7
THE TUFFY 2 YEAR WARRANTY
Tuffy 5000 Cord/Cordless Trimmer come with a
2 year warranty from date of purchase against any
manufacturing fault. Lithium Ion Batteries only come
with 12 month warranty against manufacturing fault
As you would expect, the warranty does not cover the following:
• Normal wearing parts (lever, latch, hinge, nameplate, bearings,
housing, blade etc)
• Repairs or disassembly attempted by anyone other than an authorised
service centre
• Repairs made due to normal wear and tear, abuse, improper maintenance,
or dropping.
• Any alterations made to the unit.
• Damage due to blade coolants or other chemicals.
• Damage resulting from shipping or transit.
For warranty work, please visit www.botanybayimports.com.au for a list
of service and warranty agents. When sending warranty work to an agent
please include a proof of purchase. Please check our trouble shoot guide to
ensure it is not a common or easy to solve problem.
The product that is sent in for warranty that is over 6 months old and up to 2
years old, warranty parts will be replaced but where the products has done a
lot of work a service charge will be applied.
Our goods come with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a replacement or refund for
a major failure and for compensation for any other reasonably foreseeable
loss or damage. You are also entitled to have the goods repaired or replaced
if the goods fail to be of acceptable quality and the failure does not amount
to a major failure.
Inward postage is to be paid by the customer. Return postage will be paid on
all warranty repairs. As part of all repairs, blades will also be sharpened for a
nominal charge, as this is the most common cause of poor performance.
Optional Blades
• Contact Botany Bay Imports for optional blades

8
Warranty registration on the internet or via return of the warranty
registration card is required within 30 days (thirty days) of the purchase date
for coverage of the equipment. Visit www.shearmagic.net.au
SERVICE INFORMATION
If maintenance service or service under warranty is required, please call
02 4624 8950 or visit www.botanybayimports.com.au for a list of repairers.
When returning the product for service or warranty please ensure the
following:
• Postage is prepaid
• Use sturdy packaging to protect the product against damage in transit -
such damage is not covered by the warranty
• Include your name, address and proof of purchase
• Provide a detailed description of the fault
• When sending a clipper do send the blades - but not attached to the clipper
to avoid damage in transit.
Product: Shear Magic Model: Tuffy 5000 Cord/Cordless Trimmer
Customer Name:
Address:
Phone:
Email:
Date of Purchase:
Reseller:
REGISTER YOUR PRODUCT ONLINE: WWW.SHEARMAGIC.NET.AU