Shift3 Black Series User manual

Windscreen Manual
6 pcs Washer 4 pcs Expansion Bolt
This box includes the following parts
4 pcs Screw
Attention, handle with CARE.
If in wind, rain, snow or bad wether conditions,
it is recommended to close the screen to avoid damage.
2 pcs Bracket 4pcs Expansion Tube The Stand Fix

Windscreen Manual
1. Mark positions for wall drilling 2. Drill holes in the wall
4. Insert the cassette into the bracket,
tighten the head screw
3. Fix brackets with screws

Windscreen Manual
5. Mark positions for ground drilling 6. Drill holes on the ground and fix the front bar
8. Put the handle into the stand column7. Hold the handle and pull it out
We sincerely hope you have enjoyed assembling your wind screen and that you will make good use of it.
©2016 The Investment Company Europe B.V., Shift, The BlackSeries, and The Black Series by Shift are
trademarks and/or registered trademarks of The Investment Company Europe B.V. All rights reserved.
Distributed by The Investment Company Europe B.V.
The artwork and design of this manual are protected by EU copyright law and may not be reproduced,
distributed, displayed, published or used for any purpose without proper written permission. It is not permitted to alter, remove or
reproduce any trademarks or copyright notice from this manual.