EC7500/EC7600 Caster Set - How to Assemble
！
！！
！
WARNING !
Read this manual carefully before assembly and keep this manual at a particular
place so that you can reread
it whene er you ha e a question about its use.
Assembly procedure
Figure.1 Position of Wheel guard
Figure.2 Remo e the plate
１
１１
１．
．．
．Remove the plate
Remove the plateRemove the plate
Remove the plate
(1)
Remove the cutting-off wheel.
(2)
Loosen the knob and slide the wheel guard forward
tighten the knob. ee figure 1.
(3)
Loosen the two bolts and remove the plate.
ee figure 2.
※ Note: Keep the two bolts for reuse.
※ Note: Keep the plate. The plate must be used again
when using the machine without caster.
２
２２
２．
．．
．Install the caste
Install the casteInstall the caste
Install the caster
rr
r
(1)Position the caster as figure 3.
Make sure the caster wheel is downward to the ground.
(2)Hand-tighten the four bolts. Tighten the two M5x20mm
bolts securely first and then the other two M5x14mm
bolts.
※ Note: Reuse the M5x20mm bolts which were removed at
the above procedure.1-(3)
※ Note: Tighten the M5x20mm bolts first.
(3)Reinstall the cutting-off wheel.
Figure.3 Install the caster
！
！！
！
WARNING !
Tighten all bolts securely. Using the machine with loosening bolts may cause a severe injury.
Tighten all bolts securely. Using the machine with loosening bolts may cause a severe injury.Tighten all bolts securely. Using the machine with loosening bolts may cause a severe injury.
Tighten all bolts securely. Using the machine with loosening bolts may cause a severe injury.
X750395-0701
M5×14mm
(two bolts)
M5×20mm
(two bolts)
