Shinko HG208-60 User manual

WWW.SHINKOAIRCON.COM [e-mail]

WWW.SHINKOAIRCON.COM [e-mail]

WWW.SHINKOAIRCON.COM [e-mail]
series
HG208-60
HG208-60S
HG208-90
HG208-90S
Size
cm
60
90
Color
White/Black
SS
White/Black
SS
Carbon filter
yes
Logo/ Brand
SHINKO
Manual
English
Plug
EU PLUG
the length of the cable from the outlet
of the appliance
1.1M
Voltage/Frequency
V/Hz
220~240/50
220~240/50
input Power
W
93
93
Number of Motors
n°.
1（with temperature protector)
1（with temperature protector)
Max.Motor Power
W
90
90
Free Air flow c.pty.: exhaust (max)
m³/h
295
295
Noise level
dB(A)
52
52
Appliance Dimension (without Chimney
Pipe) W/D/H
mm
600X500X140
900X500X140
Type of Switch Rocker/slider/push
Buttons
/
Push button
Push button
Filter
/
Aluminum filter
Aluminum filter
Dimension of pipe connection
mm
Φ120
Φ120
packing dimensions W X D X H
mm
637x172x525
937x172x525
Net Weight
kg
5.1
6.5
Gross Weight
kg
5.9
7.5
CE
yes
yes
Carton box
Brown carton box
Brown carton box

information and advice
Specifications: 220-240 V/50Hz 103W
In certain circumstances electrical appliance may be a danger hazard.
1) There shall be adequate ventilation of the room when the range hood is used at the
same time as appliances burning gas or other fuels.
2)Do not check the status of the filters while the range hood is operating.
3)Do not touch the light bulb within half an hour after appliance use.
4)Do not flambe under the range hood.
5)Avoid opening gasometer when there is no pan on the stove，as it is damaging for
the filters and a fire hazard.
6)Constantly check food frying to avoid that the overheated oil may become a fire
hazard.
7) Disconnect the electrical plug prior to any maintenance.
8) There is a fire risk if cleaning is not carried out in according with the instructions
9)The air must not be discharged into a fuel that is used for exhausting fumes from
appliances burning gas or other fuels
10) Regulations concerning the discharge of air have to be fulfilled
11) Warning：this appliance is not intended for use by young children and infirm
persons unless they have been adequately supervised by a responsible person to
ensure that they can use the appliance safely
12) Warning：Young children should be supervised to ensure that they do not play
with the appliance.
13) Warning：If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or a similarly qualified person in order to avoid a hazard.

Know your range hood
Please read these instructions before using your cooker hood
1. Air duct assembly 2. Main body
3.Filter assembly
Also included
*Damper flap *Drill hole stencil
*Chimney fixed bolster *User instructions
Information
Congratulations on the
purchase of our Cooker
hood , which is designed to
include many superior
features that permit you the
fullest expression of your
living. Before installing
and/or using the cooker hood
carefully read all the
instructions.
i

1
Selection of Venting Direction
Fully convertible for vertical horizontal or ductless operation
1
Information
The air must not be
discharged into a flue that
is used for exhausting
fumes form appliances
burning gas or other fuels
Regulations concerning
the discharge of air have
to be fulfilled
i

Vertical discharge
Vertical is the most common. If you select
vertical discharge, you need firstly to lock
t
he plastic cover “A”by hand and then
contra rotate the cover to take it down (see pic2).
You must make sure that the ducting knockout
B is not removed.
.
Horizontal discharge
Assuming that the range hood is located
against an outside wall, horizontal discharge
is preferred provided that there are
no obstructions such as, wall joists,
or where openings are difficult to make.
If you select horizontal discharge, you
need firstly to lock the plastic cover “B”
by hand and then contra rotate the cover
to take it down (see pic 3).
You must make sure thatA is not removed.
i
i
Information
Sufficient air is
needed for proper
combustion and
exhausting of gases
through the flue
（chimney）of fuel
burning equipment
to prevent back
drafting

Ductless
In a ductless installation the air is re-circulated
back into the kitchen. If you do not anticipate
heavy cooking this method will be preferred.
It will not be necessary to remove any duct
knockouts, you only need chose knockout C.
You should use filters to help remove cooking
odors. These filters must be washed and replaced
at regular intervals.
After selecting venting direction and
completing installation，you can turn
the knob to achieve ductless or duct.,
Open the filter, then you can see the knob.
The knob arrowhead as per FIG.7，then
it is duct.
The knob arrowhead as per
FIG.6，then it is ductless.
Information
Ductless fans
must always
be vented to
the outdoors.
i
Knob
5
6
7
7

Installation
Ensure the power has been turned off before beginning this installation
To install this hood you will require
two assistants.
You will need the following tools and
material to complete this installation:
*Drill*Flat head screwdriver*Phillips
head screwdriver or cordless drill and
Phillips head bit*Tin snips*3/8''nut
driver or ratchet with extension*measuring
tape*hand saw or jig saw*electrical tape*
duct tape。
1. Remove the range hood from the carton.
2. Lay the hood upside down on a table
covered with cardboard or paper to prevent
scratching of the table or hood.
3. Hood installation should be within 0.8m
radius range.
4. We recommend that after installation the
bottom of the hood should be no less than
700mm and no more than 750mm above
the stove's heating elements and burners.
Information
Installation work
and electrical
wiring must be
done by qualified
person(s) in
accordance with all
applicable codes
and standards,
including fire rated
construction
i
8

1. According to the figure, make sure
the position of hood in the cabinet.
The wood strips should be line
up with the 4 keyholes slots on the
top of the range hood. On the cabinet,
install 4 screws(supplied) according
to the relative position of 4 key holes
on the bottom of hood. The extent of
screwing should be convenience
to the next installation.
3. Install screws in the security holes，in
case of front and back moving of hood，
so that the using is safer.
2. Hang the hood and let it's 4 key
holes aim at screws; the 4 screws
should be in the narrow parts of
key holes. Screws should be fastened
firmly, make sure that the installation
between the hood and cabinet is
enough fasten.
Security hole 9
9
Information
When
cutting or
drilling
into wall or
celling do
not damage
electrical
wiring or
other
hidden
utilities.
i

Security hole
10
10
If the installation surface in cabinet don't adapt to install the cooker
hood, then as per FIG. 5, fix the position of cooker hood on the wall.
On the wall, install 2 screws (supplied) according to the relative
position of 2 key holes on the back of hood. The extent of screwing
should be convenience to the next installation. Also install screws in
the security holes, in case of front and back moving of hood,
so that the using is safer.
Information
The cooker hood
must be installed
and connected to
flues where other
appliances are
installed and
which run off other
energy supplied
different to
electricity (water
heaters boiler
cookers (range/a
gas) etc.,).
i

11
1、Adjust the knob to be right
position.
2、Insert the power plug firmly.
12
Press the switch of light to be on，the
bulbs light on. Otherwise, the bulbs
don't work. When press the push
button "1”: on，the motor runs
at low speed. When press the push
button "2" on，the motor runs at
middle speed. When presses the
push
button "3" on，the motor runs at high
speed. When press the push button
"0" on，the motor stops running.
1
Replacing Bulb: Removing the bulb
that need to be replaced ，then
reinstall the new bulb. The power of
bulb must not be more than 25W.
Information
Clean
Ventilating
Fans
Frequently
Grease
Should not
be allowed
to
accumulate
on fan or
filter.
i
13

Cleaning Instructions
Disconnect range hood from power supply before cleaning or servicing.
1. Cleaning the surface of hood every week. Use mild soap or
detergent to clean the hood.
2. Avoid the use of scouring powers or dishwasher compounds.
3. Grease filter may be washed using mild soap or detergent when
use it three months. (Heavy grease build-up may not be cleaned
easily and the filter may require replacement)
4. Do not use harsh alkalis or abrasives.
5. Charcoal filters cannot be cleaned and must be replaced when use
it six months.
Information
When
cleaning
water must
not inter
into motor,
control
switch etc.
electrical
parts.
i

Install the connecting ring
The manufacturer shall decline all responsibility if the foregoing recommendations
and instruction regarding installation, maintenance and use are not observed and
respected when using the cooker hood.
The appliance has two exhaust holes:
One at the front;
One at the back;
Chose a exhaust holes, then insert the
Connecting ring in the exhaust hole, revolve
it some angles (about 10°)
The connecting ring is installed
14
°
°
15
Install the carbon filter:
Push the carbon filter and then circumvolve
90°clockwise. (See FigA)
Take-down the carbon filter:
Take the carbon filter and then contra rotate
90°. (See Fig B)

WWW.SHINKOAIRCON.COM [e-mail]
Get In Touch
SHINKO AIRCON TRADING & MAINTENANCE L.L.C
Office No: 203, Burj Nahar Views building
166-Omar Bin Khattab Street, Naif- Deira
PO Box: 283018, Dubai-UnitedArab Emirates
Mob: [phone]
e-mail: [e-mail] / [e-mail]
Web: www.shinkoaircon.com