Shiratech IoT-Box User manual
IoT-Box
Quick Start Guide
Page 1of 2
IoT-Box /Quick Start Guide
/
www.shiratech-solutions.com
Rev 1.0
Quick Start
Follow these instructions to start using your IoT-Box:
1. Download the IoT-Box Debian image from http://www.shiratech-solutions.com/products/iot-box/.
2. Extract the file and flash the image to an SD card (using Win32DiskImager or any other similar tool).
3. Insert the SD card to the IoT-Box.
4. Connect the IoT-Box to your PC using a micro USB cable via the Console micro USB
connector and turn the power switch on.
5. Connect to the IoT-Box via the serial interface (using TeraTerm/Putty or any similar tool)
with a 115200 baud rate.
6. Type:
~$: nmtui
to launch the wifi settings and connect to wifi. Once wifi connection has been established
you may update and upgrade the Debian OS using:
~$: sudo apt-get update
~$: sudo apt-get upgrade
7. Test Bluetooth connectivity using the following commands:
~$: hciconfig
~$: hciconfig hci0 up
~$: hcitool scan
Console
SD card
Power Switch
Page 2of 2
IoT-Box /Quick Start Guide
/
www.shiratech-solutions.com
Rev 1.0
8. In /usr/shiratech/azure_demo folder you will find an Azure IoTC connectivity demo
application. In order to run the demo, you may refer to the readme file located in this
folder.
9. /usr/shiratech/SPI/ contains the leds.sh test script:
./leds.sh red –lights up the LED’s in red. (green/blue/off also apply).
./leds.sh –(without a parameter) will print the leds.sh script usage instructions.
10. /usr/shiratech/BG96/ contains test scripts for the BG96 modem.
T. +972.3.943.5050 F. +972.3.943.5055 E. info@shiratech-solutions.com
58 Amal St, Kiryat Arie POB 3272, Petach Tikva 4951358, Israel
www.shiratech-solutions.com
Table of contents
Other Shiratech Gateway manuals
