Shuttle PCP21 User manual

Product Specifications
w w w . s h u t t l e . e u
Shuttle Computer Handel s GmbH
Fr itz -St rassman n-Str. 5
25337 Elmsh orn | Ger many
Tel. [phone]
Fax [phone]
sale s@shu ttl e.eu
Page 1 23 September 2019
© 2018 by Shuttle Computer Handels GmbH (Germany). All information subject to change without notice. Pictures for illustration purposes only.
Shuttle XPC Accessory PCP21 -
Two COM port adapters for P20U/P51U
The Shuttle XPC all-in-one P20U/P51U comes with two COM ports as
standard. Adding PCP21, two more COM ports will be available
which makes it a total of four serial COM ports (RS232) with Sub-D
connectors.
Feature Highlights
Scope of
delivery
- 2x COM port adapter
- 4x affixing screw (UNC 4-40 thread)
- Installation guide
Ports
External: Sub-D, 9-pin, male
Internal: 10-pin (2×5), female, 2 mm pitch
Cable
9-pin ribbon cable
Length: Approx. 21 cm
Compatibility
This accessory is compatible with the
Shuttle XPC all-in-one Barebone P20U and P51U.
Shuttle XPC accessory
PCP21
2x COM Port Adapter
Images for illustration purposes only.
Shuttle XPC all-in-one P20U
before and after the installation of PCP21

Product Specifications
w w w . s h u t t l e . e u
Shuttle Computer Handel s GmbH
Fr itz -St rassman n-Str. 5
25337 Elmsh orn | Ger many
Tel. [phone]
Fax [phone]
sale s@shu ttl e.eu
Page 2 23 September 2019
© 2018 by Shuttle Computer Handels GmbH (Germany). All information subject to change without notice. Pictures for illustration purposes only.
Quick Installation Guide for PCP21
Due to safety reasons, please turn off your computer completely first
and unplug it from the power supply.
1. Unscrew four screws of the back
cover.
2. Pull the back cover upward and
put it aside. Unscrew the two screws
of the D-Sub (VGA) port on the
motherboard and remove the D-Sub
(VGA) cable.
3. Remove the two perforated
covers from the chassis which is
where the new COM ports are to be
installed.
4. Take the two COM port adapters
PCP21 out of the packaging and
remove the hexagon screws.

Product Specifications
w w w . s h u t t l e . e u
Shuttle Computer Handel s GmbH
Fr itz -St rassman n-Str. 5
25337 Elmsh orn | Ger many
Tel. [phone]
Fax [phone]
sale s@shu ttl e.eu
Page 3 23 September 2019
© 2018 by Shuttle Computer Handels GmbH (Germany). All information subject to change without notice. Pictures for illustration purposes only.
5. Insert the two D-Sub connectors of
the COM port adapter PCP21 in the
corresponding openings and affix
them with the supplied screws.
6. Connect the adapter cables to
the "COM 3" and "COM 4" headers
on the daughter board.
7. Remove Jumper "JP13" from the
daughter board in order to activate
the new COM ports.
8. Reconnect the D-Sub (VGA) cable to "VGA1" and replace the back cover,
then refasten the screws.