Siemens CAB-MP User manual

Siemens Building Technologies
Fire Safety
P/N 315-033012-1
INTRODUCTION The SIEMENS Model CAB-MP Mounting Plate i u ed in CAB1, CAB2, CAB3 enclo-
ure for mounting the y tem module . A total of one CAB-MP can be in talled in
the CAB1, two CAB-MP can be in talled in the CAB2, and three CAB-MP can be
in talled in the CAB3.
INSTALLATION
Remove BATTERY and AC prior to working on equipment.
Refer to Figure 1 on page 2.
There i a top and bottom to the CAB-MP Mounting Plate. The top i where the word
TOP i tamped on the Mounting Plate.
1. Hold the CAB-MP in your hand with the word TOP at the top of the
plate. Place the four ¼ hole on the CAB-MP Mounting Plate over the
threaded tud in the de ired location in the CAB enclo ure.
2. Secure in place with the 10-32 nut upplied.
COMPATIBILITY The CAB-MP can be u ed in CAB1, CAB2, and CAB3 enclo ure .
SPECIFICATIONS CAB-MP Mounting Plate: 19.18W x 14.25H
System Mounting Plate
Installation Instructions
Model CAB-MP

Siemens Building Technologies, Inc.
8 Fernwood Road
Florham Park, New Jersey 0 932
Siemens Building Technologies, Ltd.
2 Kenview Boulevard
Brampton, Ontario L6T 5E4 CN P/N 315-033012-1
Figure 1
Installing The CAB-MP
CAB BACKBOX
“TOP” OF CAB-MP
CAB-MP MOUNTING
PLATE
THREADED STUDS
(4 PLACES)
10-32 NUTS
(4 PLACES)