Silentaire Scorpion FS-MA 1000B User manual

8614 Veterans Memorial. Houston, Texas, 77088
832/327-7452 800/972-7668 Fax: [phone]
E-mail: [email protected]
SILENTAIRE
TECHNOLOGY
Scorpion FS-MA 1000B
Double Piston Compressor

8614 Veterans Memorial. Houston, Texas, 77088
832/327-7452 800/972-7668 Fax: [phone]
E-mail: [email protected]
Thank you and congratulations on the purchase of your SCORPION compressor.
The SCORPION is built to the highest quality standards which produce excellent
efficiency. If you use it properly and maintain it according to this manual, it will
perform to your fullest satisfaction for many years to come. Please read this
manual, carefully and follow the instructions, it will guarantee you a troublefree
operation.
A. Installation
1. After taking your SCORPION compressor out of its packaging,
please check it carefully for any damages due to shipping.
2. Install the compressor on a flat surface in a suitable sized, dry room
with good ventilation, where the temperature is not likely to rise
above 94 Degrees Farenheit (35 Centigrades).
3. Dispose of the packing material in compliance with the regulations
in the country or state where the compressor is installed.
B. Safety
1. Do Not use the OILLESS compressor for purposes other than those
for which it has been designed.
2. Do Not modify or repair the compressor while it is connected to the
electric current.
3. Note: The electric outlet has to be properly installed and grounded!
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR
MOISTURE..
This "bolt of lightning" indicates uninstalled material within your
unit may cause an electrical shock. For the safety of everyone
please do not remove product covering.
T
he "exclamation point" calls attention to features for which you
should
read the enclosed literature closely to prevent operating and
maintenance problems.

8614 Veterans Memorial. Houston, Texas, 77088
832/327-7452 800/972-7668 Fax: [phone]
E-mail: [email protected]
C. Operating Instructions
1. Connect the equipment for your application to the outgoing ¼” male
fitting at the front of the cylinder head. To keep the connecting
fitting from leaking air you should always applpy Teflon Tape to the
thread of the fitting.
2. When the compressor gets hot from constantly producing
compressed air, it automatically shuts off. After waiting for about
20 minutes to cool down, it will start working again.

8614 Veterans Memorial. Houston, Texas, 77088
832/327-7452 800/972-7668 Fax: [phone]
E-mail: [email protected]
EXPLODED VIEW AND PARTS LIST FS-MA-1000 B

8614 Veterans Memorial. Houston, Texas, 77088
832/327-7452 800/972-7668 Fax: [phone]
E-mail: [email protected]
101 Motor
102 Front Case
103 Front Cover
104 Capacitor & On/Off Switch
105 Rod
106 Ball Bearing
107 Crankshaft
108 Screw
109 Inlet & Exhaust Plate
110 Screw
111 Cylinder
112 Compression Ring
113 Collar
114 Cylinder Base
115 O-Ring
116 Valve Plate Set
117 O-Ring
118 Cylinder Head
119 Adjustable & Release
Valve
121 Nut
122 Handle
123 Handle Screw
124 Connector
125 Water Filter
126 Connector
127 Nut for Air Hose
128 Air Hose
129 Nut forAir Hose
130 Connector
131 Elbow
132 Pressure Switch
133 Screw
134 Screw
135 Screw