SILISYSTEM CLONE 433 AU 2T Setup guide

PROGRAMMABLE REMOTE CONTROL
PLEASE READ ENTIRELY THESE
INSTRUCTIONS FOR THE PROPER USE
OF THE PRODUCT!
CLONE 433 AU 2T
INSTRUCTIONS FOR
USE AND SET UP
REV. 25-10-2016

The radio control CLONE 433 AU 2T can duplicate any type of remote control with
permanent code, with transmission frequency of 433.92 MHz
WHEN TO USE IT?
HOW TO PROGRAM IT?
At the same time press two
bottons of CLONE 433 AU 2T
Red Led will firstly turns on steady
and then will turns off
Red Led will start to flash
1 - SET UP
PICT. 1
By holding firmly down the botton
that you want to program, leave the
other one
The Green Led will emit a series of
flashes and then will turn off for
processing the signal, at the end will
become steady: set up succeeded.
Get close like (in picture1) two
radio controls and press the
botton to duplicate
A fast red LED flashing indicates that there was an error in the programming, in this
case leave all bottons, wait until the led turns off and start again.

This model NOT NEED any calibration.
HOW TO SET UP THE FREQUENCY?
By using a screwdriver, put it in the hole of the key ring and by
leveraging on the edge of the radio control, remove the metal
stop, after that raise the cover, remove the dead battery and
insert the new one paying attention to the correct polarity.
The remote control is powered by a MOD. 23A DA 12V
Remove a dead battery and insert the new one paying
attention to the correct polarity.
HOW TO REPLACE THE BATTERY?
WARNING: Do not disperse the old battery into the environment,
but dispose it in dedicated waste container.
CLONE 433 AU 2T
PROGRAMMABLE REMOTE CONTROL

REV. 25-10-2016
Product designed and manufactured in Italy by
SILISYSTEM TECHNOLOGY s.r.l.
Via Marconi, 38 - 81030 Sant’Arpino (CE)
[email protected] - www.silisystem.com
CONFORMITY DECLARATION
The CLONE 433 AU 2T radio control complies with the essential requirements of the following standards:
ETSI EN300 220-2 Short Range Device (SRD)
EN 301 489-1 Electromagnetic Compatibility (EMC)
EN60950 Safety
The device CLONE 433 AU 2T has been proved in a typical configuration of installation and complies
with the essential requirements and the other relevant provisions laid down by Directive:
1999/5/CE (R&TTE Directive)
CE/108/2004 (EMC Directive)
CE/95/2006 (LVD Directive)
Andrea D'Alia
Sant Arpino (CE) 05/15/2015
Transmission frequency
European Market: 433.92
MHz
CLONE 433 AU 2T
RADIOCOMANDO PROGRAMMABILE