SILISYSTEM CLONE AF 4T Setup guide

PROGRAMMABLE REMOTE CONTROL
CLONE AF 4T
INSTRUCTIONS
FOR USE AND SET UP
PLEASE READ ENTIRELY THESE
INSTRUCTIONS FOR THE PROPER USE
OF THE PRODUCT!
REV 25-10-2016

The remote control CLONE AF 4T can duplicate any type of remote control with permanent code
with a transmission of frequency between 433,92MHz - 868,35 MHz e da 300 MHz a 350Mhz.
Warning: the transmission band from 300 to 350 MHz is prohibited within the European
Community. We recommend that you do not use it in these countries.
WHEN TO USE IT?
HOW TO PROGRAM IT?
At the same time press any two
bottons you wish of remote control
CLONE AF 4T
Red Led will firstly turn on steady
and then will turns off
Red Led will starts to flash
1 - SET UP
PICT. 1
Leave two buttons and press the
remote control button that you want
to program
The Green Led will emit a series of
flashes and then becomes Orange to
indicate the correct code acquisition
Get close like (in picture1) two
radio controls and press the
botton to duplicate
A fast red LED flashing indicates that there was an error in the programming, in this
case leave all bottons, wait until the led turns off and start again.

This model NOT NEED any calibration.
HOW TO SET UP THE FREQUENCY?
CLONE AF 4T
PROGRAMMABLE REMOTE CONTROL
By using a phillips head screwdriver, unscrew the screw at
the back of the CLONE AF 4T remote control.
The remote control is powered by a 3V
LITHIUM BATTERY with initials CR2032
Remove a dead battery and insert the new one paying
attention to the correct polarity.
HOW TO REPLACE THE BATTERY?
WARNING: Do not disperse the old battery into the environment,
but dispose it in dedicated waste container.

REV 25-10-2016
Product designed and manufactured in Italy by
SILISYSTEM TECHNOLOGY s.r.l.
Via Marconi, 38 - 81030 Sant’Arpino (CE)
[email protected] - www.silisystem.com
CONFORMITY DECLARATION
The CLONE AF 4T radio control complies with the essential requirements of the following standards:
ETSI EN300 220-2 Short Range Device (SRD)
EN 301 489-1 Electromagnetic Compatibility (EMC)
EN60950 Safety
With the current “SILISYSTEM TECHNOLOGY srl” declares that:
The device “CLONE AF 4T” has been proved in a typical configuration of installation and complies with
the essential requirements and the other relevant provisions laid down by Directive:
1999/5/CE (R&TTE Directive)
CE/108/2004 (EMC Directive)
CE/95/2006 (LVD Directive)
Andrea D'Alia
Sant Arpino (CE) 05/15/2015
Transmission frequency
European Market: :
433.92 MHz
868.3 MHz
CLONE AF 4T
PROGRAMMABLE REMOTE CONTROL